Search results
Results from the WOW.Com Content Network
Shearing, also known as die cutting, [1] is a process that cuts stock without the formation of chips or the use of burning or melting. Strictly speaking, if the cutting blades are straight the process is called shearing; if the cutting blades are curved then they are shearing-type operations. [2]
Shear forming, also referred as shear spinning, is similar to metal spinning. In shear spinning the area of the final piece is approximately equal to that of the flat sheet metal blank. The wall thickness is maintained by controlling the gap between the roller and the mandrel. In shear forming a reduction of the wall thickness occurs.
In engineering, shear strength is the strength of a material or component against the type of yield or structural failure when the material or component fails in shear. A shear load is a force that tends to produce a sliding failure on a material along a plane that is parallel to the direction of the force. When a paper is cut with scissors ...
Shear line (locksmithing), where the inner cylinder ends and the outer cylinder begins in a cylinder lock; Shearing (manufacturing), a metalworking process which cuts stock without the formation of chips or the use of burning or melting; Shear (sheet metal), various tools to shear sheet metal; Board shear, in bookbinding, a tool to cut board or ...
This software may include applications for computer-aided design (CAD), computer-aided engineering (CAE), computer-aided manufacturing (CAM) and product data management (PDM). The list is far from complete or representative as the CAD business landscape is very dynamic: almost every month new companies appear, old companies go out of business ...
Strength depends upon material properties. The strength of a material depends on its capacity to withstand axial stress, shear stress, bending, and torsion.The strength of a material is measured in force per unit area (newtons per square millimetre or N/mm², or the equivalent megapascals or MPa in the SI system and often pounds per square inch psi in the United States Customary Units system).
The relevant information is the area of the material being sheared, i.e. the area across which the shearing action takes place, and the shear strength of the material. A round bar of steel is used as an example. The shear strength is calculated from the tensile strength using a factor which relates the two strengths.
The formula to calculate average shear stress τ or force per unit area is: [1] =, where F is the force applied and A is the cross-sectional area.. The area involved corresponds to the material face parallel to the applied force vector, i.e., with surface normal vector perpendicular to the force.