Search results
Results from the WOW.Com Content Network
Although sometimes referred to as the "NV(NP)231HD," the transfer cases are actually the 241 series used in full-sized trucks from other makers (241D or 241C). The Jeep version is labelled "NV(NP)241J." This is not the NV241OR transfer case found in the Jeep Wrangler Rubicon, which uses a 4.0 low range and has a reinforced case.
The Dana 300 part-time gear-driven transfer case. [2] That uses a round bolt pattern and has a nearly flat oil pan. It is a heavy-duty, gear-driven transfer case with a 23-spline input shaft. The case is cast iron but the tail housing is aluminum. The ID number C300-15 is stamped on the case.
The TH400 AMC case was used until the end of 1979 model production. The 232 cu in (3.8 L) I6 used in 1970-72 Jeep DJ "Postal Jeep" was backed up by the Borg-Warner T-35 3-speed automatic. At the time of the acquisition, Kaiser-Jeep was using a GM 2-speed Powerglide transmission in the DJ-5A (with the GM-sourced 2.5L I4).
A notable feature available in this generation was the automatic four-wheel drive option called Quadra-Drive, which employed the New Venture Gear NV247 transfer case. This two-speed chain-driven transfer case uses a gerotor, a clutch pack coupled to a hydraulic pump, to transfer torque between the front and rear axles. The transfer case ...
Inside of a 231 New Process Gear transfer case. Part-time/Manual, shift on the fly Part-time/Manual, shift on the fly A transfer case is an intermediate gearbox that transfers power from the transmission of a motor vehicle to the driven axles of four-wheel-drive , all-wheel-drive , and other multi-axled on- and off-road machines.
The Jeep Wrangler (pictured is a TJ Wrangler) is a 4WD vehicle with a transfer case to select low-range or high-range four-wheel drive.. A four-wheel drive, also called 4×4 ("four by four") or 4WD, is a two-axled vehicle drivetrain capable of providing torque to all of its wheels simultaneously.
During those early months of 2008, Roy and Ivan spoke daily, working out the kinks in the new cooler and fine-tuning its manufacture on the fly. One day that September, Roy emailed Ivan a question.
The Syracuse New Process Gear plant produced transfer cases for all of the "Big Three"—Ford, Chrysler, and General Motors. The NV247 all-wheel drive transfer case, sold by Chrysler's Jeep division as the "Quadra-Trac II," the manual transaxle for the Dodge Neon and PT Cruiser (T-350), and manual transaxles for European-export Chrysler ...