Search results
Results from the WOW.Com Content Network
An industrial furnace, also known as a direct heater or a direct fired heater, is a device used to provide heat for an industrial process, typically higher than 400 degrees Celsius. [1] They are used to provide heat for a process or can serve as reactor which provides heats of reaction.
Propane burner with a Bunsen flame Oxy-Acetylene for cutting through steel rails Flame of a gas and oil, in a dual burner. A gas burner is a device that produces a non-controlled flame by mixing a fuel gas such as acetylene, natural gas, or propane with an oxidizer such as the ambient air or supplied oxygen, and allowing for ignition and ...
Boilers generally have 2 or 3 pressuretrols: a manual-reset pressuretrol, which functions as a safety by setting the upper limit of steam pressure, the operating pressuretrol, which controls when the boiler fires to maintain pressure, and for boilers equipped with a modulating burner, a modulating pressuretrol which controls the amount of fire.
The Venturi CSA is optimally 43% of the Burner CSA, and positions and lengths of tubes are described in the document. The "optimum" expansion beyond the venturi is at 2 degrees taper (4 degrees included angle). This design of "Inspirator" can be seen in many domestic and industrial gas burners in use today.
A combustor is a component or area of a gas turbine, ramjet, or scramjet engine where combustion takes place. It is also known as a burner, burner can, combustion chamber or flame holder. In a gas turbine engine, the combustor or combustion chamber is fed high-pressure air by the compression system. The combustor then heats this air at constant ...
A single-ended recuperative (SER) burner is a type of gas burner used in high-temperature industrial kilns and furnaces. These burners are used where indirect heating is required, e.g. where the products of combustion are not allowed to combine with the atmosphere of the furnace. The typical design is a tubular (pipe) shape with convoluted ...
The powdered coal from the pulverizer is directly blown to a burner in the boiler. The burner mixes the powdered coal in the air suspension with additional pre-heated combustion air and forces it out of a nozzle similar in action to fuel being atomized by a fuel injector in an internal combustion engine. Under operating conditions, there is ...
It is well established that conventional "blue flame" or bunsen gas burners produce oxides of nitrogen at levels of 30-50 nanograms per joule [5] [6] and are as such not considered to have potential for NO x reduction. Surface combustion burners or radiant tile burners in comparison produce nitrogen oxides' levels 60-70% less. [6]