Ads
related to: rigol ds1054z xy mode 2 channel amplifier
Search results
Results from the WOW.Com Content Network
RIGOL was founded in Beijing in 1998 and released its first product, a high-performance virtual digital storage oscilloscope, in May 1999. [1]In 2018 the company released the new RSA5000 real-time spectrum analyzer and the MSO7000, as well as MSO5000 series, based on the new ASIC based Ultravision-II platform.
The X-Y mode also lets the oscilloscope serve as a vector monitor to display images or user interfaces. Many early games, such as Tennis for Two, used an oscilloscope as an output device. [12] Complete loss of signal in an X-Y CRT display means that the beam is stationary, striking a small spot.
The inductive output tube (IOT) or klystrode is a variety of linear-beam vacuum tube, similar to a klystron, used as a power amplifier for high frequency radio waves. It evolved in the 1980s to meet increasing efficiency requirements for high-power RF amplifiers in radio transmitters. [ 1 ]
A bridge-parallel amplifier topology is a hierarchical combination of the bridged and paralleled amplifier topologies, with at least four single-ended channels needed to produce one bridge-parallel channel. The two topologies complement each other in that the bridging allows for higher voltage output and the paralleling provides the current ...
[2] [3] The power gain of the tube is on the order of 40 to 70 decibels, [3] and output power ranges from a few watts to megawatts. [2] [3] TWTs are widely used as the power amplifiers and oscillators in radar systems, communication satellite and spacecraft transmitters, and electronic warfare systems. [2] Diagram of helix TWT
A class-B push–pull amplifier is more efficient than a class-A power amplifier because each output device amplifies only half the output waveform and is cut off during the opposite half. It can be shown that the theoretical full power efficiency (AC power in load compared to DC power consumed) of a push–pull stage is approximately 78.5%.
Lissajous curves can also be generated using an oscilloscope (as illustrated). An octopus circuit can be used to demonstrate the waveform images on an oscilloscope. Two phase-shifted sinusoid inputs are applied to the oscilloscope in X-Y mode and the phase relationship between the signals is presented as a Lissajous figure.
The use of a cascode (sometimes verbified to cascoding) is a common technique for improving analog circuit performance, applicable to both vacuum tubes and transistors.The name "cascode" was coined in an article written by Frederick Vinton Hunt and Roger Wayne Hickman in 1939, in a discussion on the application of voltage stabilizers. [3]
Ads
related to: rigol ds1054z xy mode 2 channel amplifier