enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Dado set - Wikipedia

   en.wikipedia.org/wiki/Dado_set

   A dado set or dado blade is a type of circular saw blade, typically used with a table saw or radial arm saw, which is used to cut dadoes or grooves in woodworking. [1] There are two common kinds of dado sets, stacked dado set and wobble blade. Stacked dado set consists of two circular saw blades fixed on either side of a set of removable chippers.

3. Table saw - Wikipedia

   en.wikipedia.org/wiki/Table_saw

   Stacked dado sets are available in diameters of 6, 8 and 10 inches (150, 200 and 250 mm). 8- and 10-inch stacked dado sets are not recommended for saws with 1 + 1 ⁄ 2 horsepower (1.1 kW) or less. Although 10-inch stacked dado sets are available with a 5 ⁄ 8 -inch (16 mm) bore, these are recommended with a 1-inch (25 mm) bore.

4. Flat (theatre) - Wikipedia

   en.wikipedia.org/wiki/Flat_(theatre)

   Dados can be made using a radial arm saw or table saw, and a dado stack cutter (two outer circular saw blades and one or more "chippers" between them, giving a much wider cut). Setting up for a dado stack is approximately the same as for preparing keystones and cornerblocks, but requires less layout, as the length of stiles, rails and, toggles ...

5. Radial arm saw - Wikipedia

   en.wikipedia.org/wiki/Radial_arm_saw

   A saw which combines the sliding and compound features is known as a sliding compound miter saw or SCMS. Before the advent of the radial arm saw, table saws and hand saws were most commonly used for crosscutting lumber. Table saws can easily rip stock, but it is awkward to push a long piece of stock widthwise through a table saw blade.

6. Dado (joinery) - Wikipedia

   en.wikipedia.org/wiki/Dado_(joinery)

   A through [1] dado involves cuts which run between both edges of the surface, leaving both ends open. A stopped or blind [2] dado ends before one (stopped) or both (blind) of the cuts meets the edge of the surface. [1] A half dado is formed with a narrow dado cut into one part, coupled with a rabbet of another piece. This joint tends to be used ...

7. Shurly & Dietrich - Wikipedia

   en.wikipedia.org/wiki/Shurly_&_Dietrich

   They hired nine saw makers from Rochester, New York and Sheffield, England and began to manufacture saws in Galt, Ontario, now called Cambridge. [1] [5] By 1886 the company employed 70 skilled workman. [6] The company held a number of Canadian patents for saw design. [7] By 1906, Cosmos' son Theodore Shurly was the factory superintendent. [8]

8. Circular saw - Wikipedia

   en.wikipedia.org/wiki/Circular_saw

   A hand-held circular saw is the most conventional circular saw. This miter saw is a circular saw mounted to swing to crosscut wood at an angle. A table saw. Tractor-driven circular saw. A circular saw or a buzz saw, is a power-saw using a toothed or abrasive disc or blade to cut different materials using a rotary motion spinning around an arbor.

9. Saw - Wikipedia

   en.wikipedia.org/wiki/Saw

   A "stacked" dado blade, consisting of chipper blades between two dado blades, can make different-width grooves by adding or removing chipper blades. An "adjustable" dado blade has a movable locking cam mechanism to adjust the degree to which the blade wobbles sideways, allowing continuously variable groove widths from the lower to upper design ...