Search results
Results from the WOW.Com Content Network
The warp-weighted loom is a simple and ancient form of loom in which the warp yarns hang freely from a bar, which is supported by upright poles which can be placed at a convenient slant against a wall. Bundles of warp threads are tied to hanging weights called loom weights which keep the threads taut. [1]
Tablet weaving dates back at least to the 8th century BCE in early Iron Age Europe [1] where it is found in areas employing the warp-weighted loom. [2] Historically the technique served several purposes: to create starting and/or selvedge bands for larger textiles such as those produced on the warp-weighted loom; to weave decorative bands onto ...
The sizing machine improved the process by sizing a warp before putting it into the loom. The warp threads are first wound onto a large beam, which is then placed at one end of the sizing machine. Then the warp is drawn off the beam and passes through a bath of boiling size, between sets of rollers and cooled, dried and rewound onto another beam.
From prehistory through the early Middle Ages, for most of Europe, the Near East and North Africa, two main types of loom dominated textile production. These are the warp-weighted loom and the two-beam loom. The length of the beam determined the width of the cloth woven upon the loom, and could be as wide as 2–3 meters. [26]
The shed of a jack loom is smaller for a given length of warp being pulled aside by the heddles (loom depth). The warp threads being pulled up by the jacks are also tauter than the other warp threads (unlike a counter balance loom, where the threads are pulled an equal amount in opposite directions). Uneven tension makes weaving evenly harder.
Wrapping the warp threads around the warp beam of a loom in preparation for weaving. A beamer was an occupation in the cotton industry. [1] The taper's beam is a long cylinder with flanges where 400 plus ends (threads) are wound side-by-side. Creels of bobbins with the correct thread, mounted on a beaming frame wind their contents onto the beam.
During the early Anglo-Saxon period (c. 450–650), archaeological evidence for subsistence-level wool production using warp-weighted looms is extensive. Tools and technologies of spinning and weaving were similar to those of the Roman period; it is likely that fine, white wool continued to be produced from sheep introduced from the ...
Loom beaters typically take the form of a bar mounted across the loom. The actual beating is done by a metal insert known as a reed, which contains a number of slots, known as dents, which the warp threads pass through. This is the more common form, as floor looms and mechanized looms both use a beater with a reed.