Search results
Results from the WOW.Com Content Network
In pin tumbler locks, the series of key cuts on a key causes the pins to line up at the shear line or gate so the lock will open. In warded locks, the key cuts bypass the wards so the key can push or pull the bolt. [6] Key pin In a pin tumbler lock, the key pin is in contact with the key. It has varying lengths, corresponding to the key's ...
The key will then remain trapped until the gate or door is closed. A personnel or safety key can be released from the access lock, this ensures that the gate or door can not be closed and the initial key released until this personnel or safety key is returned (assuming that no duplicate keys are available). This provides increased operator safety.
The term "warded lock" refers to the lock mechanism, while the term "mortise lock" refers to the bolt location. Warded locks contain a series of static obstructions, or wards, within the lock box; only a key with cutouts to match the obstructions will be able to turn freely in the lock and open the latch. [4]
Newer NSA systems allow "over the air rekeying" (OTAR), but a master key often must still be loaded using a fill device. NSA uses two serial protocols for key fill, DS-101 and DS-102. Both employ the same U-229 6-pin connector type used for U.S. military audio handsets, with the DS-101 being the newer of the two serial fill protocols. The DS ...
An arrow lock is metal and rectangular, measuring 2.005 in × 3.566 in × 0.620 in (50.9 mm × 90.6 mm × 15.7 mm) with a keyhole in the center. [2] When the user turns the key, a metal bar that normally protrudes from one side is moved through the lock to the other side.
The Ford Meter Box Company is a manufacturer of products for the waterworks industry and is headquartered in Wabash, Indiana, where it operates a brass foundry. Its products include water meter setting and testing equipment, valves , couplings , meter boxes , and other fittings.
Interchangeable cores require a notch at the tip of each key to properly align the peaks and valleys of each blade with the combinating pins in the chambers of the mechanism; as a consequence, these keys are always configured and cut from blade tip to bow. Conversely, conventional cylinders and removable cores use a shoulder near the bow of ...
A Piping and Instrumentation Diagram (P&ID) is a detailed diagram in the process industry which shows process equipment together with the instrumentation and control devices.