Search results
Results from the WOW.Com Content Network
This figure is determined by dividing the width (or height) of the display area in pixels by the width (or height) of the display area in inches. It is possible for a display to have different horizontal and vertical PPI measurements (e.g., a typical 4:3 ratio CRT monitor showing a 1280×1024 mode computer display at maximum size, which is a 5: ...
The term display resolution is usually used to mean pixel dimensions, the maximum number of pixels in each dimension (e.g. 1920 × 1080), which does not tell anything about the pixel density of the display on which the image is actually formed: resolution properly refers to the pixel density, the number of pixels per unit distance or area, not ...
Pixel counts can be expressed as a single number, as in a "three-megapixel" digital camera, which has a nominal three million pixels, or as a pair of numbers, as in a "640 by 480 display", which has 640 pixels from side to side and 480 from top to bottom (as in a VGA display) and therefore has a total number of 640 × 480 = 307,200 pixels, or 0 ...
This chart shows the most common display resolutions, with the color of each resolution type indicating the display ratio (e.g., red indicates a 4:3 ratio). This article lists computer monitor, television, digital film, and other graphics display resolutions that are in common use. Most of them use certain preferred numbers.
The 854 pixel width is rounded up from 853. 3: 480 × 16 ⁄ 9 = 7680 ⁄ 9 = 853 + 1 ⁄ 3. Since a pixel must be a whole number, rounding up to 854 ensures inclusion of the entire image. 853 × 480 is the 16:9 equivalent for NTSC (480 lines) on a display with square pixels.
An image that is 2048 pixels in width and 1536 pixels in height has a total of 2048×1536 = 3,145,728 pixels or 3.1 megapixels. One could refer to it as 2048 by 1536 or a 3.1-megapixel image. The image would be a very low quality image (72ppi) if printed at about 28.5 inches wide, but a very good quality (300ppi) image if printed at about 7 ...
On 2D displays, such as computer monitors and TVs, display size or viewable image size (VIS) refers to the physical size of the area where pictures and videos are displayed. The size of a screen is usually described by the length of its diagonal , which is the distance between opposite corners, typically measured in inches.
The display aspect ratio (DAR) is calculated from the physical width and height of a display, measured each in inch or cm (Display size). The pixel aspect ratio (PAR) is calculated from the width and height of one pixel. The storage aspect ratio (SAR) is calculated from the numbers of pixels in width and height stated in the display resolution.