Search results
Results from the WOW.Com Content Network
Reverse bias: Although the LED is based on a diode junction and is nominally a rectifier, the reverse-breakdown mode for some types can occur at very low voltages and essentially any excess reverse bias can cause immediate degradation, and may lead to vastly accelerated failure. 5 V is a typical maximum reverse bias voltage specification for ...
In visual perception, flicker is a human-visible change in luminance of an illuminated surface or light source which can be due to fluctuations of the light source itself, or due to external causes such as due to rapid fluctuations in the voltage of the power supply (power-line flicker) or incompatibility with an external dimmer.
The 4th generation of LED tubes offers a solution to the flickering problem. The flickering is measured using so-called flicker index or flicker percentage value. Elimination of flickering allows high-quality video recording and slow motion capture, as well as certain machine vision applications in premises equipped with flicker-free lights. [3 ...
Temporal light artefacts (TLAs) are undesired effects in the visual perception of a human observer induced by temporal light modulations. Two well-known examples of such unwanted effects are flicker and stroboscopic effect. Flicker is a directly visible light modulation at relatively low frequencies (< 80 Hz) and small intensity modulation levels.
New LED lights at Dodger Stadium gained unwanted attention from players of both teams during the Dodgers' season-opening win over the Diamondbacks.
A 230-volt LED filament lamp, with an E27 base. The filaments are visible as the eight yellow vertical lines. An assortment of LED lamps commercially available in 2010: floodlight fixtures (left), reading light (center), household lamps (center right and bottom), and low-power accent light (right) applications An 80W Chips on board (COB) LED module from an industrial light luminaire, thermally ...
As illustrated by a straight line on the chromaticity diagram, simple two-white blends will have a pink bias, becoming most severe in the middle. A small amount of green light, provided by another LED, could correct the problem. [38] Some products are RGBWW, i.e. RGBW with tunable white. [39] A final class of white LED with mixed light is dim ...
The two major innovations of the unit were the high-frequency ballast, which gave the lights greater intensity and eliminated flicker commonly found in off-the-shelf fluorescent tubes, and the Kino Flo tubes, which contained a number of special phosphors designed to eliminate the characteristic tints in the magenta-green spectrum which are present in most domestic fluorescent lights. [3]