Search results
Results from the WOW.Com Content Network
The Federal Bridge Gross Weight Formula, also known as Bridge Formula B or the Federal Bridge Formula, is a mathematical formula in use in the United States by truck drivers and Department of Transportation (DOT) officials to determine the appropriate maximum gross weight for a commercial motor vehicle (CMV) based on axle number and spacing ...
The axle load of a wheeled vehicle is the total weight bearing on the roadway for all wheels connected to a given axle.Axle load is an important design consideration in the engineering of roadways and railways, as both are designed to tolerate a maximum weight-per-axle (axle load); exceeding the maximum rated axle load will cause damage to the roadway or railway tracks.
The load can often be expressed as a curve of force versus speed. For instance, a given car traveling on a road of a given slope presents a load which the engine must act against. Because air resistance increases with speed, the motor must put out more torque at a higher speed in order to maintain the speed.
An axle or axletree is a central shaft for a rotating wheel or gear. On wheeled vehicles, the axle may be fixed to the wheels, rotating with them, or fixed to the vehicle, with the wheels rotating around the axle. [1] In the former case, bearings or bushings are provided at the mounting points where the axle is supported. In the latter case, a ...
These are the type most commonly used in automotive applications (to support the wheels of a motor car for example), where they are used in pairs to accommodate axial thrust in either direction, as well as radial loads. They can support greater thrust loads than the ball type due to the larger contact area, but are more expensive to manufacture.
The area can be the undeformed area or the deformed area, depending on whether engineering stress or true stress is of interest. Compressive stress (or compression ) is the stress state caused by an applied load that acts to reduce the length of the material ( compression member ) along the axis of the applied load; it is, in other words, a ...
For instance, a gear mounted on a shaft might use a male spline on the shaft that matches the female spline on the gear. Adjacent images in the section below show a transmission input shaft with male splines and a clutch plate with mating female splines in the center hub, where the smooth tip of the axle would be supported in a pilot bearing in ...
In 1972, the Ohio Legislature created TRC of Ohio and established the Transportation Research Board for the control, management, supervision, and direction of the Center. Subsequently, the Board hired a staff to operate the facilities. In June 1979, the Board contracted with OSU to manage the operations and staff of the TRC of Ohio.