Search results
Results from the WOW.Com Content Network
The resultant wave may have greater intensity (constructive interference) or lower amplitude (destructive interference) if the two waves are in phase or out of phase, respectively. Interference effects can be observed with all types of waves, for example, light , radio , acoustic , surface water waves , gravity waves , or matter waves as well ...
This equation, Bragg's law, describes the condition on θ for constructive interference. [12] A map of the intensities of the scattered waves as a function of their angle is called a diffraction pattern. Strong intensities known as Bragg peaks are obtained in the diffraction pattern when the scattering angles satisfy Bragg condition.
Crest and trough in a wave. A Crest point on a wave is the highest point of the wave. A crest is a point on a surface wave where the displacement of the medium is at a maximum. A trough is the opposite of a crest, so the minimum or lowest point of the wave.
William Lawrence Bragg proposed a model where the incoming X-rays are scattered specularly (mirror-like) from each plane; from that assumption, X-rays scattered from adjacent planes will combine constructively (constructive interference) when the angle θ between the plane and the X-ray results in a path-length difference that is an integer ...
Constructive interference in thin films can create a strong reflection of light in a range of wavelengths, which can be narrow or broad depending on the design of the coating. These films are used to make dielectric mirrors, interference filters, heat reflectors, and filters for colour separation in colour television cameras. This interference ...
Multipath interference is a phenomenon in the physics of waves whereby a wave from a source travels to a detector via two or more paths and the two (or more) components of the wave interfere constructively or destructively. Multipath interference is a common cause of "ghosting" in analog television broadcasts and of fading of radio waves.
Beamforming or spatial filtering is a signal processing technique used in sensor arrays for directional signal transmission or reception. [1] This is achieved by combining elements in an antenna array in such a way that signals at particular angles experience constructive interference while others experience destructive interference.
To get constructive interference at the focus, the zones should switch from opaque to transparent at radii where [3] = + where n is an integer, λ is the wavelength of the light the zone plate is meant to focus and f is the distance from the center of the zone plate to the focus.