Search results
Results from the WOW.Com Content Network
The purge valve controls the purge vapor purge line, through which the manifold vacuum pulls air through the vapor storage device and purges it of fuel vapors. The electronic control unit (ECU) controls the opening and closing of this valve. [8] [dead link ]
California vehicles with 2.5, 2.8 and 3.5 liter engines will have a CLCC system. In 1980 model year, vehicles sold in California and 3.8 and 4.3 liter engines sold federally will have CLCC, and finally in the 1981 model year all passenger cars will have the system. California light and medium duty trucks may also use the c-4 system.
In 1996, light duty vehicles (less than 8,500 lb or 3,900 kg) were the first to be mandated followed by medium duty vehicles (8,500–14,000 lb or 3,900–6,400 kg) in 2005. [1] They are both required to be accessed through a standardized data link connector defined by SAE J1962 .
The crankcase air outlet, where the PCV valve is located, is generally placed as far as possible from the crankcase breather. For example, the breather and outlet are frequently on opposite valve covers on a V engine, or on opposite ends of the valve cover on an inline engine. The PCV valve is often, but not always, placed at the valve cover ...
The early fuel evaporator is a device found in some internal combustion engines with carburetors.It can sometimes be referred to as an electronic fuel evaporator. The device on a car, commonly referred to as an EFE heater, is located between the throttle body of the carburetor and the intake manifold as a gasket and contains a resistance grid that heats the air/fuel mixture.
If the throttling valve or device is located at the entry into a pressure vessel so that the flash evaporation occurs within the vessel, then the vessel is often referred to as a flash drum. [1] [2] If the saturated liquid is a single-component liquid (for example, propane or liquid ammonia), a part of the liquid immediately "flashes" into vapor.
An air purge heating unit is used to ensure that the purge air remains at a temperature above the acid dew-point. This temperature is typically around 20 °C/68 °F. [2] If temperatures are below this point, the controls will be corroded by condensation of compounds in the flue gas. Heated air ensures that controls are dry during startup. [3]
A check engine light or malfunction indicator lamp (MIL), is a tell-tale that a computerized engine-management system uses to indicate a malfunction or problem with the vehicle ranging from minor (such as a loose gas cap) to serious (worn spark plugs, engine problems or a faulty oil valve, etc.).