Search results
Results from the WOW.Com Content Network
The molar volume of gases around STP and at atmospheric pressure can be calculated with an accuracy that is usually sufficient by using the ideal gas law. The molar volume of any ideal gas may be calculated at various standard reference conditions as shown below: V m = 8.3145 × 273.15 / 101.325 = 22.414 dm 3 /mol at 0 °C and 101.325 kPa
Until 1982, STP was defined as a temperature of 273.15 K (0 °C, 32 °F) and an absolute pressure of 101.325 kPa (1 atm). Since 1982, STP is defined as a temperature of 273.15 K (0 °C, 32 °F) and an absolute pressure of 100 kPa (1 bar). Conversions between each volume flow metric are calculated using the following formulas: Prior to 1982,
Gas undergoes a slight expansion when the temperature is raised from 15 °C (59 °F) to 60 °F and this expansion is built into the above factor for gas. The standard temperature and pressure (STP) for gas varies depending on the particular code being used. [2] It is just as important to know the standard pressure as the temperature.
The ideal gas equation can be rearranged to give an expression for the molar volume of an ideal gas: = = Hence, for a given temperature and pressure, the molar volume is the same for all ideal gases and is based on the gas constant: R = 8.314 462 618 153 24 m 3 ⋅Pa⋅K −1 ⋅mol −1, or about 8.205 736 608 095 96 × 10 −5 m 3 ⋅atm⋅K ...
To denote an amount of substance, the 'cm 3 STP ' is standard cubic centimeter, which is a unit of amount of substance rather than a unit of volume. It represents the number of gas molecules or moles that would occupy one cubic centimeter at standard temperature and pressure, as calculated via the ideal gas law.
Standard cubic centimeters per minute (SCCM) is a unit used to quantify the flow rate of a fluid. 1 SCCM is identical to 1 cm³ STP /min. Another expression of it would be Nml/min. These standard conditions vary according to different regulatory bodies.
Hydrogen, being the lightest existing gas (7% the density of air, 0.08988 g/L at STP), seems to be the most appropriate gas for lifting.It can be easily produced in large quantities, for example with the water-gas shift reaction or electrolysis, but hydrogen has several disadvantages:
Standard cubic feet per minute (SCFM) is the molar flow rate of a gas expressed as a volumetric flow at a "standardized" temperature and pressure thus representing a fixed number of moles of gas regardless of composition and actual flow conditions.