enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Category 6 cable - Wikipedia

   en.wikipedia.org/wiki/Category_6_cable

   A Cat 6 patch cable, terminated with 8P8C modular connectors. Category 6 cable (Cat 6) is a standardized twisted pair cable for Ethernet and other network physical layers that is backward compatible with the Category 5/5e and Category 3 cable standards. Cat 6 must meet more stringent specifications for crosstalk and system noise than Cat 5 and ...

3. Registered jack - Wikipedia

   en.wikipedia.org/wiki/Registered_jack

   A cable with a 50-pin connector on one end can support six fully wired 8P8C connectors or Ethernet ports on a patch panel with one spare pair. Alternatively, only the necessary pairs for 10/100 Ethernet can be wired allowing twelve Ethernet ports with a single spare pair. This connector is also used with spring bail locks for SCSI-1 connections.

4. Structured cabling - Wikipedia

   en.wikipedia.org/wiki/Structured_cabling

   Regardless of copper cable type (Cat 5e/6/6A), the maximum distance is 90 m for the permanent link installation, plus an allowance for a combined 10 m of patch cords at the ends. Cat 5e and Cat 6 can both effectively run power over Ethernet (PoE) applications up to 90 m. However, due to greater power dissipation in Cat 5e cable, performance and ...

5. ANSI/TIA-568 - Wikipedia

   en.wikipedia.org/wiki/ANSI/TIA-568

   Pinouts are critical because cables do not function if the pinouts at their two ends aren't correctly matched. The standard specifies how to connect eight-conductor 100-ohm balanced twisted-pair cabling, such as Category 5 cable, to 8P8C modular connectors (often referred to as RJ45 connectors). The standard defines two alternative pinouts ...

6. GG45 - Wikipedia

   en.wikipedia.org/wiki/GG45

   GG45 is a variant of ARJ45 that allows for cables terminated with male 8P8C (AKA RJ45) connectors to be plugged into GG45 jacks. However, GG45 cables cannot plug into 8P8C jacks as a protrusion on the socket is designed to activate a switch on the jack for the alternative contact positions.

7. ISO/IEC 11801 - Wikipedia

   en.wikipedia.org/wiki/ISO/IEC_11801

   Class C: Up to 16 MHz using Category 3 cable and connectors; Class D: Up to 100 MHz using Category 5e cable and connectors; Class E: Up to 250 MHz using Category 6 cable and connectors; Class E A: Up to 500 MHz using category 6A cable and connectors (Amendments 1 and 2 to ISO/IEC 11801, 2nd Ed.) Class F: Up to 600 MHz using Category 7 cable and ...