Search results
Results from the WOW.Com Content Network
The gateway address must be configured on each host. The network host IP interface binds the gateway address to the MAC address of the physical gateway by broadcasting IP datagrams and caching the MAC address of the reply from the gateway in an ARP table stored on the host. The gateway address may be added manually.
The IP-address could be 91.198.174.2. In this example, none of the internal routers know the route to that host, so they will forward the packet through router1's gateway or default route. [1] Every router on the packet's way to the destination will check whether the packet's destination IP-address matches any known network routes. If a router ...
NOTE: a RID is the highest logical (loopback) IP address configured on a router, if no logical/loopback IP address is set then the router uses the highest IP address configured on its active interfaces (e.g. 192.168.0.1 would be higher than 10.1.1.2). Usually the router with the second-highest priority number becomes the BDR.
The access router gives the dial-up nodes IP addresses in the range 192.168.0.128 – 192.168.0.254; for this example, assume a dial-up node gets IP address 192.168.0.254. The access router uses proxy ARP to make the dial-up node present in the subnet without being wired into the Ethernet: the access router 'publishes' its own MAC address for ...
The Interface indicates what locally available interface is responsible for reaching the gateway. In this example, gateway 192.168.0.1 (the internet router) can be reached through the local network card with address 192.168.0.100. Finally, the Metric indicates the associated cost of using the indicated route. This is useful for determining the ...
The default route in Internet Protocol Version 4 (IPv4) is designated as the zero address, 0.0.0.0 / 0 in CIDR notation. [2] Similarly, in IPv6 , the default route is specified by :: / 0 . The subnet mask is specified as / 0 , which effectively specifies all networks and is the shortest match possible.
Used for link-local addresses [5] between two hosts on a single link when no IP address is otherwise specified, such as would have normally been retrieved from a DHCP server 172.16.0.0/12 172.16.0.0–172.31.255.255 1 048 576: Private network Used for local communications within a private network [3] 192.0.0.0/24 192.0.0.0–192.0.0.255 256
The host broadcasts an ARP request containing the node's IP address, and the node with the corresponding IP address returns an ARP reply that contains its MAC address. ARP has been implemented with many combinations of network and data link layer technologies, such as IPv4 , Chaosnet , DECnet and Xerox PARC Universal Packet (PUP) using IEEE 802 ...