Search results
Results from the WOW.Com Content Network
The graph shows the impedance curve of a single loudspeaker driver in free-air (unmounted in any type of enclosure). A home hi-fi loudspeaker system typically consists of two or more drivers, an electrical crossover network to divide the signal by frequency band and route them appropriately to the drivers, and an enclosure that all these ...
All speaker drivers have a means of electrically inducing back-and-forth motion. Typically there is a tightly wound coil of insulated wire (known as a voice coil) attached to the neck of the driver's cone. In a ribbon speaker, the voice coil may be printed or bonded onto a sheet of very thin paper, aluminum, fiberglass or plastic.
The loudspeaker's nominal load impedance (input impedance) of is usually around 4 to 8 Ω, although other impedance speakers are available, sometimes dropping as low as 1 Ω or 2 Ω. However, the impedance rating of a loudspeaker is simply a number that indicates the nominal minimum impedance of that loudspeaker over a representative portion of ...
The 1925 paper [1] of Chester W. Rice and Edward W. Kellogg, fueled by advances in radio and electronics, increased interest in direct radiator loudspeakers. In 1930, A. J. Thuras of Bell Labs patented (US Patent No. 1869178) his "Sound Translating Device" (essentially a vented box) which was evidence of the interest in many types of enclosure design at the time.
Obtaining a high fidelity sound output using this technique requires a switching frequency much higher than the audio frequencies meant to be reproduced (typically with a ratio of 10:1 or more), and the output voltage to be bipolar, in order to make better use of the output devices' dynamic range and power. On the PC speaker, however, the ...
SOURCE-Impedance. 1 comment. 2 DampingFactor. 1 comment. 3 Impedance graph. 3 comments. 4 Nominal and minimum impedance. ... Talk: Electrical characteristics of ...
A speaker with a higher impedance may have lower measured sensitivity and thus appear to be less efficient than a speaker with a lower impedance even though their efficiencies are actually similar. Speaker efficiency is a metric that only measures the actual percentage of electrical power that the speaker converts to acoustic power and is ...
Constant-voltage speaker systems are also commonly referred to as 25-, 70-, 70.7-, 100 or 210-volt speaker systems; distributed speaker systems; or high-impedance speaker systems. In Canada and the US, they are most commonly referred to as 70-volt speakers. In Europe, the 100 V system is the most widespread, with amplifier and speaker products ...