enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Spin casting - Wikipedia

   en.wikipedia.org/wiki/Spin_casting

   The spin casting process typically uses vulcanized silicone or organic rubber as the mold-making substrate. Vulcanization is an integral step that occurs halfway through the mold-making process. Prior to vulcanization, the mold rubber is a soft and malleable solid-like fluid, in many ways very similar to Silly Putty. Because of the clay-like ...

3. Resin casting - Wikipedia

   en.wikipedia.org/wiki/Resin_casting

   The creation of a toy or figure start with the traditional sculpting process where the artist designs a clay sculpture. Where appropriate, for example when making a garage kit, the sculpture is dissected into several parts like head, torso, arms and legs. A flexible mold made from room temperature vulcanized (RTV) silicone rubber is made for ...

4. Release agent - Wikipedia

   en.wikipedia.org/wiki/Release_agent

   The silicone keeps the rubber from sticking to the mold but just as important it lubricates the rubber so it will slide over the hot mold as it is loaded. Diluted silicone typically has to be applied every cycle. Semi-permanent mold release builds a silicone matrix on the mold that becomes a barrier between the rubber and the metal surface of ...

5. Casting - Wikipedia

   en.wikipedia.org/wiki/Casting

   Plaster and other chemical curing materials such as concrete and plastic resin may be cast using single-use waste molds as noted above, multiple-use 'piece' molds, or molds made of small rigid pieces or of flexible material such as latex rubber (which is in turn supported by an exterior mold). When casting plaster or concrete, the material ...

6. Ceramic forming techniques - Wikipedia

   en.wikipedia.org/wiki/Ceramic_forming_techniques

   There are many forming techniques to make ceramics, but one example is slip casting. This is where slip or, liquid clay, is poured into a plaster mould. The water in the slip is drawn out into the walls of the plaster mould, leaving an inside layer of solid clay, which hardens quickly. When dry, the solid clay can then also be removed.

7. How to Make a Jell-O Mold That Comes Out Perfect

   www.aol.com/jell-o-mold-comes-perfect-150003594.html

   Use hot water to remove a stubborn Jell-O mold: If your mold isn’t releasing from the pan, set the mold in a pan of hot water for 10 seconds and try to remove it again. Repeat the process until ...