Ad
related to: front drive axle removal
Search results
Results from the WOW.Com Content Network
Center axle disconnect on a Dana 60, in a 1999 4x4 Dodge 2500HD. A center axle disconnect system or CAD is an alternative to locking hubs. CAD systems are typically used in front drive axles on four wheel drive vehicles. A CAD system works by having an axle shaft (typically the longer shaft) split into two pieces.
Twin-Traction Beam was invented by John A. Richardson and Donald G. Wheatley of Ford Motor Company covered by US patent 3,948,337 issued April 6, 1976. The patent name was “Independent front suspension for front-wheel drive” which was assigned to Ford Motor Company. [1] [2] The Dana Holding Corporation manufactured
Splines on a front drive axle. An axle that is driven by the engine or prime mover is called a drive axle. Modern front-wheel drive cars typically combine the transmission (gearbox and differential) and front axle into a single unit called a transaxle. The drive axle is a split axle with a differential and universal joints between the two half ...
The Dana 44 Front axle first saw use in the 1950s and still in use today. Dana 44 Front axles were known for utilizing locking hubs or a center axle disconnect system. However, a permanently locked-in Dana 44 is not uncommon. The Dana 44 has seen use in 1/4-, 1/2-, 3/4-, and 1-ton rated trucks.
A beam axle, rigid axle, or solid axle is a dependent suspension design in which a set of wheels is connected laterally by a single beam or shaft. Beam axles were once commonly used at the rear wheels of a vehicle, but historically, they have also been used as front axles in four-wheel-drive vehicles.
Both companies used Dana 70 front axles until the mid-1970s (Dodge W300 pickup up until 1978, discontinued in 1979). All of these Dana 70 front axles were closed knuckle, with king pins and had a GAWR of 6000 lbs. Like the rear Dana 70 axles, the Dana 70 front axle started out with 23 spline axle shafts and then went to 35 spline axle shafts.
When the front hubs are locked, even if no power is sent to the front axle (by means of a transfer case), the turning of the wheels will still spin the front axle, differential, and driveshaft, which puts extra load on the engine. Unlocking the hubs disconnects the wheels from the axle, which eliminates this extra load.
The discontinued torque-tube drive was replaced by a new design utilizing an open driveshaft and a four-link axle-location system. [16] The 1961 Pontiac Tempest was introduced as a new model, featuring an inline 4 coupled to a transaxle via a torque tube, giving it a perfect 50-50 front-rear weight balance.
Ad
related to: front drive axle removal