enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. External wall insulation - Wikipedia

   en.wikipedia.org/wiki/External_wall_insulation

   An external wall insulation system (or EWIS) is a thermally insulated, protective, and decorative exterior cladding procedure involving the use of expanded polystyrene, mineral wool, polyurethane foam or phenolic foam, topped off with a reinforced cement based, mineral or synthetic finish and plaster.

3. Exterior insulation finishing system - Wikipedia

   en.wikipedia.org/wiki/Exterior_insulation...

   Exterior insulation and finish system (EIFS) is a general class of non-load bearing building cladding systems that provides exterior walls with an insulated, water-resistant, finished surface in an integrated composite material system. EIFS has been in use since the 1960s in North America and was first used on masonry buildings.

4. Insulating concrete form - Wikipedia

   en.wikipedia.org/wiki/Insulating_concrete_form

   Insulating concrete form or insulated concrete form (ICF) is a system of formwork for reinforced concrete usually made with a rigid thermal insulation that stays in place as a permanent interior and exterior substrate for walls, floors, and roofs.

5. Building insulation material - Wikipedia

   en.wikipedia.org/wiki/Building_insulation_material

   Insulation is a barrier material to resist/reduce substance (water, vapor, etc. ) /energy (sound, heat, electric, etc.) to transfer from one side to another. Heat/ Thermal Insulation is a barrier material to resist / block / reflect the heat energy (either one or more of the Conduction, Convection or Radiation) to transfer from one side to another.

6. Structural insulated panel - Wikipedia

   en.wikipedia.org/wiki/Structural_insulated_panel

   The third component in SIPs is the spline or connector piece between SIPs. Dimensional lumber is commonly used but creates thermal bridging and lowers insulation values. To maintain higher insulation values through the spline, manufacturers use Insulated Lumber, Composite Splines, Mechanical Locks, Overlapping OSB Panels, or other creative methods.

7. Precast concrete - Wikipedia

   en.wikipedia.org/wiki/Precast_concrete

   In a typical 8-inch wall panel the concrete wythes are each 2-3/8 inches thick), sandwiching 3-1/4 inches of high R-value insulating foam. The interior and exterior wythes of concrete are held together (through the insulation) with some form of connecting system that is able to provide the needed structural integrity.