enow.com Web Search

  1. Ad

    related to: 4g lte antenna diy

Search results

  1. Results from the WOW.Com Content Network
  2. Cellular repeater - Wikipedia

    en.wikipedia.org/wiki/Cellular_repeater

    A cellular repeater (also known as cell phone signal booster or cell phone signal amplifier) is a type of bi-directional amplifier used to improve cell phone reception. [citation needed] A cellular repeater system commonly consists of a donor antenna that receives and transmits signal from nearby cell towers, coaxial cables, a signal amplifier, and an indoor rebroadcast antenna.

  3. 4G-LTE filter - Wikipedia

    en.wikipedia.org/wiki/4G-LTE_filter

    4G LTE is the fourth generation mobile phone standard. In urban areas, the 4G uses a frequency band located between 1800 MHz and 2600 MHz, and therefore is quite far from the TV band for causing any type of interference problem. In rural areas, however, the major operators asked to use part of the UHF band.

  4. LTE (telecommunication) - Wikipedia

    en.wikipedia.org/wiki/LTE_(telecommunication)

    In telecommunications, long-term evolution (LTE) is a standard for wireless broadband communication for cellular mobile devices and data terminals. It is considered to be a "transitional" 4G technology, [1] and is therefore also referred to as 3.95G as a step above 3G.

  5. 4G - Wikipedia

    en.wikipedia.org/wiki/4G

    The pre-4G 3GPP Long Term Evolution (LTE) technology is often branded "4G – LTE", but the first LTE release does not fully comply with the IMT-Advanced requirements. LTE has a theoretical net bit rate capacity of up to 100 Mbit/s in the downlink and 50 Mbit/s in the uplink if a 20 MHz channel is used — and more if multiple-input multiple ...

  6. MIMO - Wikipedia

    en.wikipedia.org/wiki/MIMO

    The first 4G cellular standard was proposed by NTT DoCoMo in 2004. [29] Long term evolution (LTE) is based on MIMO-OFDM and continues to be developed by the 3rd Generation Partnership Project (3GPP). LTE specifies downlink rates up to 300 Mbit/s, uplink rates up to 75 Mbit/s, and quality of service parameters such as low latency. [30]

  7. Antenna diversity - Wikipedia

    en.wikipedia.org/wiki/Antenna_diversity

    Antenna diversity is especially effective at mitigating these multipath situations. This is because multiple antennas offer a receiver several observations of the same signal. Each antenna will experience a different interference environment. Thus, if one antenna is experiencing a deep fade, it is likely that another has a sufficient signal ...

  8. LTE frequency bands - Wikipedia

    en.wikipedia.org/wiki/LTE_frequency_bands

    Networks on LTE bands 1, 3 (LTE-FDD) are suitable for roaming in ITU Regions 1, 3 and partially Region 2 (e.g. Costa Rica, Venezuela, Brazil and some Caribbean countries or territories. Networks on LTE band 20 (LTE-FDD) are suitable for roaming in ITU Region 1 only. Networks on LTE band 5 (LTE-FDD) are suitable for roaming in ITU Regions 2 and 3.

  9. C-RAN - Wikipedia

    en.wikipedia.org/wiki/C-RAN

    C-RAN (Cloud-RAN), also referred to as Centralized-RAN, is an architecture for cellular networks. [1] [2] [3] C-RAN is a centralized, cloud computing-based architecture for radio access networks that supports 2G, 3G, 4G, 5G and future wireless communication standards.

  1. Ad

    related to: 4g lte antenna diy