Search results
Results from the WOW.Com Content Network
A spray nozzle or atomizer is a device that facilitates the dispersion of a liquid by the formation of a spray. The production of a spray requires the fragmentation of liquid structures, such as liquid sheets or ligaments, into droplets, often by using kinetic energy to overcome the cost of creating additional surface area.
The following formulas can be used to calculate the volumes of solute (V solute) and solvent (V solvent) to be used: [1] = = where V total is the desired total volume, and F is the desired dilution factor number (the number in the position of F if expressed as "1/F dilution factor" or "xF dilution"). However, some solutions and mixtures take up ...
In fire protection engineering, the K-factor formula is used to calculate the volumetric flow rate from a nozzle. Spray nozzles can for example be fire sprinklers or water mist nozzles, hose reel nozzles, water monitors and deluge fire system nozzles.
Mixing of liquids occurs frequently in process engineering. The nature of liquids to blend determines the equipment used. Single-phase blending tends to involve low-shear, high-flow mixers to cause liquid engulfment, while multi-phase mixing generally requires the use of high-shear, low-flow mixers to create droplets of one liquid in laminar, turbulent or transitional flow regimes, depending ...
Although, thorough mixing of gases and vapors may not be as easily accomplished. [citation needed] For example, if there are 10 grams of salt (the solute) dissolved in 1 litre of water (the solvent), this solution has a certain salt concentration . If one adds 1 litre of water to this solution, the salt concentration is reduced.
Assume that the molar volume (V) is known from EOS calculations, and prior vapor-liquid equilibrium (VLE) calculations for mixtures. Then the two functions P h {\displaystyle P_{h}} and P a {\displaystyle P_{a}} can be utilized, and these functions are expected to be a more accurate and robust than the molar volume (V) itself.
Spray nozzle manufacturers all tabulate capacity based on water. Since the specific gravity of a liquid affects its flow rate, the values must be adjusted using the equation below, where Qw is the water capacity and Spg is the specific gravity of the fluid used resulting the volumetric flow rate of the fluid used Qf.
In locations where a municipal connection is not possible or practical, the required water may be drawn from an open body of water (e.g., lake, pond, river) or a water storage tank. Hydraulic calculations determine if the available water supply pressure is adequate to provide the sprinkler system design flowrate.