Search results
Results from the WOW.Com Content Network
[1] [2] The Ashley Book of Knots shows this intermediate knot, in stopper form, as #521. [3] While it uses more rope and is bulkier than the figure-of-eight loop, the figure-nine loop is somewhat stronger and less likely to jam. [1] It is sometimes used instead of a figure-of-eight loop to attach a rope to an anchor point or belay. [2]
The figure-eight knot or figure-of-eight knot is a type of stopper knot. It is very important in both sailing and rock climbing as a method of stopping ropes from running out of retaining devices. Like the overhand knot , which will jam under strain, often requiring the rope to be cut, the figure-eight will also jam, but is usually more easily ...
Recommended dimensions and layouts will vary with different building codes around the world, but some examples are: [4] [5] No leg of the triangle should be less than 1.2 m (4 ft) or more than 2.7 m (9 ft). The sum of all three sides of the triangle should be between 4–8 m (13–26 ft).
For premium support please call: 800-290-4726 more ways to reach us
A simple marble-topped washstand. A washstand or basin stand is a piece of furniture consisting of a small table or cabinet, usually supported on three or four legs, and most commonly made of mahogany, walnut, or rosewood, and made for holding a wash basin and water pitcher.
It is Harley's 13th birthday, but it seems no one remembers. Harley believes her parents will feel guilty about forgetting her special day, and decides to use that "guilt" to get the best seat in the family car as a present—the sweet seat, reserved for the oldest child, which is Rachel.
A glass stopper is often called a "ground glass joint" (or "joint taper"), and a cork stopper is called simply a "cork". Stoppers used for wine bottles are referred to as "corks", even when made from another material. [citation needed] A common every-day example of a stopper is the cork of a wine bottle.
One component is a rod that is inserted into the existing hole in the workpieces; the other component is the cutter, which is attached to the rod, or extends out of it, after it is in position. [3] This is comparable to other types of "back-" machining, such as back-spotfacing, back-boring, back-counterboring, back-milling, and back-deburring.