Search results
Results from the WOW.Com Content Network
A ball valve is a flow control device which uses a hollow, perforated, and pivoting ball to control fluid flowing through it. It is open when the hole through the middle of the ball is in line with the flow inlet and closed when it is pivoted 90 degrees by the valve handle, blocking the flow. [1]
Valves are available in several types, based on design and purpose: Gate, plug, or ball valves – Isolation; Globe valve – Throttling; Needle valve – Throttling, usually with high precision but low flow; Butterfly or diaphragm valves – Isolation and throttling; Check valve – Preventing reverse flow (non-return)
MEP's design is important for planning, decision-making, accurate documentation, performance- and cost-estimation, construction, and operating/maintaining the resulting facilities. [ 1 ] MEP specifically encompasses the in-depth design and selection of these systems, as opposed to a tradesperson simply installing equipment.
Schematic 3 way ball valve: L-shaped ball right, T-shaped left. Valves with three ports serve many different functions. A few of the possibilities are listed here. Three-way ball valves come with T- or L-shaped fluid passageways inside the rotor. The T valve might be used to permit connection of one inlet to either or both outlets or connection ...
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
The main valve block is usually a stack of off the shelf directional control valves chosen by flow capacity and performance. Some valves are designed to be proportional (flow rate proportional to valve position), while others may be simply on-off. The control valve is one of the most expensive and sensitive parts of a hydraulic circuit.
A compound meter is used where high flow rates are necessary, but where at times there are also smaller rates of flow that need to be accurately measured. Compound meters have two measuring elements and a check valve to regulate flow between them. At high flow rates, water is normally diverted primarily or completely to the high flow element.
Water can dribble into this tank through a 12 mm pipe, plus ball valve, and then supply the house on 22 or 28 mm pipes. Gravity water has a small pressure (say 1 ⁄ 4 bar in the bathroom) so needs wide pipes to allow for higher flows. This is fine for baths and toilets but is frequently inadequate for showers.