enow.com Web Search

  1. Ad

    related to: guitar amp repair input jack

Search results

  1. Results from the WOW.Com Content Network
  2. RCA connector - Wikipedia

    en.wikipedia.org/wiki/RCA_connector

    The connector’s male plug and female jack are called RCA plug and RCA jack. It is also called RCA phono connector [ 5 ] or phono connector . [ 6 ] [ 7 ] The word phono in phono connector is an abbreviation of the word phonograph , because this connector was originally created to allow the connection of a phonograph turntable to a radio receiver.

  3. Guitar amplifier - Wikipedia

    en.wikipedia.org/wiki/Guitar_amplifier

    The 1/4" input jack is typically mounted on the front of the amplifier. In the simplest, least expensive amplifiers, this 1/4" jack is the only jack on the amplifier. The patch bay at the rear panel of this Line 6 Flextone guitar amp provides several additional inputs and outputs, including stereo XLR DI unit outputs.

  4. Audio and video interfaces and connectors - Wikipedia

    en.wikipedia.org/wiki/Audio_and_video_interfaces...

    A phone connector (tip, ring, sleeve) also called an audio jack, phone plug, jack plug, stereo plug, mini-jack, or mini-stereo. This includes the original 6.35 mm (quarter inch) jack and the more recent 3.5 mm (miniature or 1/8 inch) and 2.5 mm (subminiature) jacks, both mono and stereo versions. There also exists 4.4 mm Pentaconn connectors.

  5. Phono input - Wikipedia

    en.wikipedia.org/wiki/Phono_input

    Phono input is a set of input jacks, usually mini jacks or RCA connectors, located on the rear panel of a preamp, mixer or amplifier, especially on early radio sets, to which a phonograph or turntable is attached. [1] Modern phono cartridges give a very low level output signal of the order of a few millivolts which the circuitry amplifies and ...

  6. Dumble Amplifiers - Wikipedia

    en.wikipedia.org/wiki/Dumble_Amplifiers

    A few Dumble amps have a Dumbleator circuit built in, but most have "un-buffered" input jacks that tap directly out of the pre-amp and into the power amp. Dumble likely created this external loop because of the difficulty of fitting effects loop buffering into the amplifier chassis (and the limited use of effects loops for most players).

  7. Guitar tech - Wikipedia

    en.wikipedia.org/wiki/Guitar_tech

    A guitar tech is often a "jack of all trades," expected to make simple repairs: resolder a loose wiring connection inside a guitar, replace an amplifier tube, swap out a damaged speaker for a new one, reglue a loose part on an acoustic guitar, or adjust a truss rod. In cases where there is either not enough time to make the repair, or if the ...

  8. Mesa/Boogie - Wikipedia

    en.wikipedia.org/wiki/Mesa/Boogie

    Mesa was started by Randall Smith as a small repair shop which modified Fender amplifiers, particularly the diminutive Fender Princeton. Smith's modifications gave the small amps much more input gain, making them much louder as well as creating a high-gain, distorted guitar tone.

  9. Sound reinforcement system - Wikipedia

    en.wikipedia.org/wiki/Sound_reinforcement_system

    Three audio power amplifiers Rear panel of a power amplifier with 2 × 700 Watt (4 Ohm) - very similar to the topmost device in the image above - showing typical connectors for professional use: From left, symmetrical XLR-sockets for signal input, alternatively audio jack sockets, loudspeaker terminals of type Speakon (center), alternatively ...

  1. Ad

    related to: guitar amp repair input jack