Search results
Results from the WOW.Com Content Network
Oil conversion factor from m³ to bbl (or stb) is 6.28981100 Gas conversion factor from standard m³ to scf is 35.314666721 Note that the m³ gas conversion factor takes into account a difference in the standard temperature base for measurement of gas volumes in metric and imperial units.
Metric regions commonly use the tonne of oil equivalent (toe), or more often million toe (Mtoe). Since this is a measurement of mass, any conversion to barrels of oil equivalent depends on the density of the oil in question, as well as the energy content. Typically 1 tonne of oil has a volume of 1.08 to 1.19 cubic metres (6.8 to 7.5 bbl).
Conversion of units is the conversion of the unit of measurement in which a quantity is expressed, typically through a multiplicative conversion factor that changes the unit without changing the quantity. This is also often loosely taken to include replacement of a quantity with a corresponding quantity that describes the same physical property.
Most wet scrubbers used for particulate control operate with liquid-to-gas ratios in the range of 4 to 20 gallons per 1,000 actual cubic foot (0.5 to 3 litres per actual cubic metre). Depending on scrubber design, a minimum volume of liquid is required to "wet" the scrubber internals and create sufficient collection targets.
The volume of such a mixture is slightly less than the sum of the volumes of the components. Thus, by the above definition, the term "40% alcohol by volume" refers to a mixture of 40 volume units of ethanol with enough water to make a final volume of 100 units, rather than a mixture of 40 units of ethanol with 60 units of water.
US dry barrel: 7,056 cubic inches (115.6 litres; 3.3 US bushels) . Defined as length of stave 28 + 1 ⁄ 2 in (72 cm), diameter of head 17 + 1 ⁄ 8 in (43 cm), distance between heads 26 in (66 cm), circumference of bulge 64 in (160 cm) outside measurement; representing as nearly as possible 7,056 cubic inches; and the thickness of staves not greater than 4 ⁄ 10 in (10 mm) [2] (diameter ≈ ...
The fuel consumption is an equivalent measure for cars sold outside the United States, typically measured in litres per 100 km traveled; in general, the fuel consumption and miles per gallon would be reciprocals with appropriate conversion factors, but because different countries use different driving cycles to measure fuel consumption, fuel ...
On average, U.S. petroleum refineries produce about 19 to 20 gallons of gasoline, 11 to 13 gallons of distillate fuel diesel fuel and 3 to 4 gallons of jet fuel from each 42 gallon (152 liters) barrel of crude oil. The product ratio depends upon the processing in an oil refinery and the crude oil assay. [19]