enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Infiltration/Inflow - Wikipedia

   en.wikipedia.org/wiki/Infiltration/Inflow

   Groundwater entering sanitary sewers through defective pipe joints and broken pipes is called infiltration. [4] Pipes may leak because of careless installation; they may also be damaged after installation by differential ground movement, heavy vehicle traffic on roadways above the sewer, careless construction practices in nearby trenches, or degradation of the sewer pipe materials.

3. Pipe dope - Wikipedia

   en.wikipedia.org/wiki/Pipe_dope

   Petroleum-based pipe dope is not intended for use on threaded PVC, CPVC or ABS pipe and fittings since it will deteriorate the plastic. Builders in the US are expected to use thread compounds that meet ASTM F2331 - Standard Test Method for Determining Chemical Compatibility of Thread Sealants with Thermoplastic Threaded Pipe and Fittings Materials or thread seal tape on PVC, CPVC and ABS threads.

4. Heat fusion - Wikipedia

   en.wikipedia.org/wiki/Heat_fusion

   As current is applied to the resistive wire, the coils heat up and melt the inside of the fitting and the outside of the pipe wall which weld together producing a very strong homogeneous joint. The assembly is then left to cool for a specified time. The joints produced tend to be more reliable than threaded fittings sealed with O-rings. [9]

5. Cured-in-place pipe - Wikipedia

   en.wikipedia.org/wiki/Cured-in-place_pipe

   It is a jointless, seamless pipe lining within an existing pipe. As one of the most widely used rehabilitation methods, CIPP has applications in sewer, water, gas, chemical and district heating pipelines ranging in diameter from 0.1 to 2.8 meters (2–110 inches).

6. Flare fitting - Wikipedia

   en.wikipedia.org/wiki/Flare_fitting

   For high pressure, flare joints are made by doubling the tube wall material over itself before the bell end is formed. The double flare avoids stretching the cut end where a single flare may crack. Before the flaring step, the end of the tube is compressed axially causing the tube wall to yield radially outward forming a bubble.

7. Piping and plumbing fitting - Wikipedia

   en.wikipedia.org/wiki/Piping_and_plumbing_fitting

   The bodies of fittings for pipe and tubing are often the same base material as the pipe or tubing connected: copper, steel, PVC, CPVC, or ABS. Any material permitted by the plumbing, health, or building code (as applicable) may be used, but it must be compatible with the other materials in the system, the fluids being transported, and the ...