enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Data terminal equipment - Wikipedia

   en.wikipedia.org/wiki/Data_terminal_equipment

   This communication is done via an Ethernet crossover cable as opposed to a PC to DCE (hub, switch, or bridge) communication which is done via an Ethernet straight cable. V.35 is a high-speed serial interface designed to support both higher data rates and connectivity between DTEs (data-terminal equipment) or DCEs (data-communication equipment ...

3. List of ITU-T V-series recommendations - Wikipedia

   en.wikipedia.org/wiki/List_of_ITU-T_V-Series...

   V.32 (11/88) is an ITU-T recommendation for a modem operating as full-duplex on a 4-wire circuit, or half-duplex on a two-wire circuit, allowing bidirectional data transfer at either 9.6 kbit/s or 4.8 kbit/s at a symbol rate of 2,400 baud instead of the 600 baud of the V.22 standards.

4. VESA Enhanced Video Connector - Wikipedia

   en.wikipedia.org/wiki/VESA_Enhanced_Video_Connector

   M1-A EVC cable. The VESA Enhanced Video Connector (EVC) is a VESA standard that was intended to reduce the number of cables around a computer by incorporating video, audio, FireWire and USB into a single cable system, terminating in a 35-pin Molex MicroCross connector. The intent was to make the monitor the central point of connection.

5. List of video connectors - Wikipedia

   en.wikipedia.org/wiki/List_of_video_connectors

   The signal standard and pinout are backward-compatible with CGA, allowing EGA monitors to be used on CGA cards and vice versa. Early VGA cards also used this connector. VGA connector (DE-15) Became a nearly ubiquitous analog computer display connector after first being introduced with IBM x86 machines. Older VGA connectors were DE-9 (9-pin).

6. ANSI/TIA-568 - Wikipedia

   en.wikipedia.org/wiki/ANSI/TIA-568

   Perhaps the most comprehensively known and most discussed feature of ANSI/TIA-568 is the definition of the pin-to-pair assignments, or pinout, between the pins in a connector (a plug or a socket) and the wires in a cable. Pinouts are critical because cables do not function if the pinouts at their two ends aren't correctly matched.

7. IDC (electrical connector) - Wikipedia

   en.wikipedia.org/wiki/IDC_(electrical_connector)

   Pin 1 is typically indicated on the body of the connector by a red or raised "V" mark. The corresponding wire in a ribbon cable is usually indicated by red coloration, a raised molded ridge, or markings printed onto the cable insulation. On the connector pin 2 is opposite pin 1, pin 3 is next to pin 1 along the length of the connector, and so on.

8. These Low-Maintenance Ground Cover Plants Will Protect ... - AOL

   www.aol.com/grow-low-maintenance-ground-cover...

   The feathery plants are slow to grow, but once they do, they're sure to add a mystical effect to your garden. Zones: 3 to 8 Care requirements: Full shade; well-draining soil

9. CCJ connector - Wikipedia

   en.wikipedia.org/wiki/CCJ_connector

   Close-up of the same Hirose-made CCJ connector with embossed numerical pinout. The CCJ connector (short for Camera Cable type J [2]), also known as a J-type connector [1]: 62–63 or an EIAJ connector, [3]: 192 is the specification for a 10-pin DIN-style connector established by member companies of the Electronic Industries Association of Japan (EIAJ) in the late 1960s to interconnect various ...