Search results
Results from the WOW.Com Content Network
A hydraulic system is required for high speed flight and large aircraft to convert the crews' control system movements to surface movements. The hydraulic system is also used to extend and retract landing gear, operate flaps and slats, operate the wheel brakes and steering systems.
The systems evolved, replacing the mechanical linkages to the valves with electrical controls, producing the "fly-by-wire" design, [3] and more recently, optical networking systems called "fly-by-light". All these systems require three separate components, the hydraulic supply system, the valves and associated control network, and the actuators.
A yaw damper may remove the necessity for a pilot to make any contact with the rudder pedals during turns on a range of aircraft, including jet-powered ones. [2] [3] Some aircraft, such as the Boeing 727 and Vickers VC10 airliners, are fitted with multiple yaw damper systems due to their operation having been deemed critical to flight safety ...
An oleo strut is a pneumatic air–oil hydraulic shock absorber used on the landing gear of most large aircraft and many smaller ones. [1] This design cushions the impacts of landing and damps out vertical oscillations.
In aviation, a power transfer unit (PTU) is a device that transfers hydraulic power from one of an aircraft's hydraulic systems to another in the event that the other system has failed or been turned off. The PTU is used when, for example, there is right hydraulic system pressure but no left hydraulic system pressure.
The hydraulic fluid is also used as a preservative fluid for aircraft hydraulic systems and components where MIL-H-5606 (OHA) or MIL-PRF-87257 is used as an operational fluid." [ 18 ] Synthetic hydrocarbon base: These synthetic fluids are compatible with mineral-base hydraulic fluids and were developed to address the low flash point draw back ...
Axial piston pumps are used to power the hydraulic systems of jet aircraft, being gear-driven off of the turbine engine's main shaft, The system used on the F-14 used a 9-piston pump that produced a standard system operating pressure of 3000 psi and a maximum flow of 84 gallons per minute.
Derived from the words hydraulics and pneumatics, pneudraulics is the term used when discussing systems on military aircraft that use either or some combination of hydraulic and pneumatic systems. [1] The science of fluids made of both gas and liquid.