Search results
Results from the WOW.Com Content Network
The ISO 2848 basic module is a unit of 100 mm, often represented by a single capital "M", along with 300 mm and 600 mm groupings, that is widely used for the widths of furniture in Europe. A standard metric (concrete) block is 190 mm wide, 390 mm long, and 190 mm high, which allows for 10 mm mortar joints in between bricks, giving a standard ...
The sortable table below contains the three sets of ISO 3166-1 country codes for each of its 249 countries, links to the ISO 3166-2 country subdivision codes, and the Internet country code top-level domains (ccTLD) which are based on the ISO 3166-1 alpha-2 standard with the few exceptions noted. See the ISO 3166-3 standard for former country codes.
A metric ISO screw thread is designated by the letter M followed by the value of the nominal diameter D (the maximum thread diameter) and the pitch P, both expressed in millimetres and separated by a dash or sometimes the multiplication sign, × (e.g. M8-1.25 or M8×1.25). If the pitch is the normally used "coarse" pitch listed in ISO 261 or ...
This template is part of a series that resolves the country and subdivision names to ISO 3166-1 and ISO 3166-2 codes, and vice versa. ISO 3166 defines names, two and three letter codes and code numbers for all countries and six character codes (the two letter country code followed by a dash and a two or three character subdivision code) for all top level subdivisions.
This template is part of a series that resolves the country and subdivision names to ISO 3166-1 and ISO 3166-2 codes, and vice versa. ISO 3166 defines names, two and three letter codes and code numbers for all countries and six character codes (the two letter country code followed by a dash and a two or three character subdivision code) for all top level subdivisions.
The standard designation for a UTS thread is a number indicating the nominal (major) diameter of the thread, followed by the pitch measured in threads per inch.For diameters smaller than 1 / 4 inch, the diameter is indicated by an integer number defined in the standard; for all other diameters, the inch figure is given.
ISO 3166 Maintenance Agency, International Organization for Standardization (ISO) Standard Country or Area Codes for Statistical Use, United Nations Statistics Division Countries or areas, codes and abbreviations — list of alpha-3 and numeric codes (a few territories officially assigned codes in ISO 3166-1 are not included in this list)
Example (inch, fine): For 7 ⁄ 16-20 (same diameter as the previous example, but this time with 20 threads per inch, which is considered fine), 0.437 in × 0.90 = 0.393 in (i.e., if the threads are to be fine, then a slightly larger diameter drill bit should be used before tapping the hole for the screw).