Ad
related to: transistor cross ref symbol list
Search results
Results from the WOW.Com Content Network
The IEEE 315 standard contains a list of Class Designation Letters to use for electrical and electronic assemblies. For example, the letter R is a reference prefix for the resistors of an assembly, C for capacitors, K for relays. Industrial electrical installations often use reference designators according to IEC 81346.
An electronic symbol is a pictogram used to represent various electrical and electronic devices or functions, such as wires, batteries, resistors, and transistors, in a schematic diagram of an electrical or electronic circuit. These symbols are largely standardized internationally today, but may vary from country to country, or engineering ...
On a circuit diagram, the symbols for components are labelled with a descriptor or reference designator matching that on the list of parts. For example, C1 is the first capacitor, L1 is the first inductor, Q1 is the first transistor, and R1 is the first resistor. Often the value or type designation of the component is given on the diagram ...
Some TTL logic parts were made with an extended military-specification temperature range. These parts are prefixed with 54 instead of 74 in the part number. [1]A short-lived 64 prefix on Texas Instruments parts indicated an industrial temperature range; this prefix had been dropped from the TI literature by 1973.
For the BJT, on an n–p–n transistor symbol, the arrow will "Not Point iN". On a p–n–p transistor symbol, the arrow "Points iN Proudly". However, this does not apply to MOSFET-based transistor symbols as the arrow is typically reversed (i.e. the arrow for the n–p–n points inside).
Size comparison of BJT transistor packages, from left to right: SOT-23, TO-92, TO-126, TO-3 3D model of TO-3 package. In electronics, TO-3 is a designation for a standardized metal semiconductor package used for power semiconductors, including transistors, silicon controlled rectifiers, and, integrated circuits.
Voltage reference integrated circuit (National Semiconductor LH0070) in a TO-205-AF package. TO-205 is intended to replace previous definitions of packages with leads arranged in a circle with a diameter of 5.08 mm (0.200 in).
Multiple-emitter transistors replace the diodes of diode–transistor logic (DTL) to make transistor–transistor logic (TTL), [1] and thereby allow reduction of switching time and power dissipation. [2] [3] cross section and symbol of a simple NPN bipolar transistor cross section and symbol of a multiple emitter NPN bipolar transistor
Ad
related to: transistor cross ref symbol list