Search results
Results from the WOW.Com Content Network
Shoring is designed to prevent collapse where shielding is only designed to protect workers when collapses occur. Concrete-structure and stone-building shoring, in these cases also referred to as falsework, provides temporary support until the concrete becomes hard and achieves the desired strength to support loads.
A jack post (telepost, adjustable steel column) is a steel post used in the construction trades for temporary support of ceilings, walls and trenches ().They are designed to be able to mechanically telescope to about twice their shortest length in order to span a wide variety of spaces.
Continuous flight augering can be used to construct a secant piled wall which can be used as a retaining wall or as shoring during excavation. Once initial piles are set with concrete, other shafts are augured between them, slicing into the original piles, with the new ones receiving rebar .
Category for the construction methods involved in the shoring (to avoid collapse of retaining walls) of excavation Subcategories This category has the following 4 subcategories, out of 4 total.
Trench shoring is the process of bracing the walls of a trench to prevent collapse and cave-ins. The phrase can also be used as a noun to refer to the materials used in the process. The phrase can also be used as a noun to refer to the materials used in the process.
The tieback-deadman structure resists forces that would otherwise cause the wall to lean, as for example, when a seawall is pushed seaward by water trapped on the landward side after a heavy rain. Tiebacks are drilled into soil using a small diameter shaft, and usually installed at an angle of 15 to 45 degrees.
A list, usually tabular and often on the drawing (if not accompanying the drawing on a separate sheet), listing the parts needed in an assembly, including subparts, standard parts, and hardware. There is no consistently enforced distinction between an L/M, a BoM, or a P/L. PLM: product lifecycle management; plant lifecycle management: See also ...
DWG is merely descriptive of applicant's goods under Section 2(e)(1) of the Trademark Act for two reasons: (1) DWG is a recognized abbreviation for "drawing," and (2) .dwg is a file format used for computer-aided design (CAD) drawings made both with applicant's CAD software and others' CAD software. Autodesk appealed the decision.