Ads
related to: high current load switchebay.com has been visited by 1M+ users in the past month
Search results
Results from the WOW.Com Content Network
Unlike general-purpose relays, contactors are designed to be directly connected to high-current load devices. Relays tend to be of lower capacity and are usually designed for both normally closed and normally open applications. Devices switching more than 15 amperes or in circuits rated more than a few kilowatts are usually called contactors.
In three-phase electric power, they only eliminate the phases where the fault current is flowing, which can pose a risk for both the malfunctioning devices and the people. To alleviate this problem, fuses can be used in conjunction with high-current switches or contactors. Like contactors, high-voltage fuses are used only in the band 30 kV to ...
Inrush current, input surge current, or switch-on surge is the maximal instantaneous input current drawn by an electrical device when first turned on. Alternating-current electric motors and transformers may draw several times their normal full-load current when first energized, for a few cycles of the input waveform.
Isolators are off load disconnectors which are to be operated after Circuit Breakers, or else if the load current is very small; By voltage class: Low voltage (less than 1 kV AC) Medium voltage (1 kV AC through to approximately 75 kV AC) High voltage (75 kV to about 230 kV AC) Extra high voltage, ultra high voltage (more than 230 kV)
A high-voltage disconnect switch used in an electrical substation. Such switches are used mostly to isolate circuits, and usually cannot break load current. High-voltage switches are available for the highest transmission voltages, up to 1 million volts. This switch is gang-operated so that all three phases are interrupted at the same time.
Contacts of a high-voltage switch employing open air as an insulating medium. When relay contacts open to interrupt a high current with an inductive load, a voltage spike will result, striking an arc across the contacts. If the voltage is high enough, an arc may be struck even without an inductive load.
Ads
related to: high current load switchebay.com has been visited by 1M+ users in the past month