Search results
Results from the WOW.Com Content Network
The Crumbuino-Mega is a low-cost module comparable to the Arduino-Mega 2560 and can be used as Arduino-Mega 2560 in the Arduino-IDE. The Arduino bootloader is preloaded, hence the module is ready-to-use. The documentation shows the pin mapping of Arduino-naming to module pinout. Cuteduino: ATtiny85 Cytron Technologies: Cuteduino Features:
ESP32 is a series of low-cost, low-power system-on-chip microcontrollers with integrated Wi-Fi and dual-mode Bluetooth.The ESP32 series employs either a Tensilica Xtensa LX6 microprocessor in both dual-core and single-core variations, an Xtensa LX7 dual-core microprocessor, or a single-core RISC-V microprocessor and includes built-in antenna switches, RF balun, power amplifier, low-noise ...
SparkFun ESP8266 Thing. The reason for the popularity of many of these boards over the earlier ESP-xx modules is the inclusion of an on-board USB-to-UART bridge (like the Silicon Labs' CP2102 or the WCH CH340G) and a Micro-USB connector, coupled with a 3.3-volt regulator to provide both power to the board and connectivity to the host (software development) computer – commonly referred to as ...
Traditionally, Arduino IDE was used to program Arduino's official boards based on Atmel AVR Microcontrollers, but over time, once the popularity of Arduino grew and the availability of open-source compilers existed, many more platforms from PIC, STM32, TI MSP430, ESP32 can be coded using Arduino IDE.
Arduino – a popular microcontroller board family ESP32 – a series of low-cost, low-power system on a chip microcontrollers with integrated Wi-Fi and dual-mode Bluetooth. STM32 – a family of 32-bit microcontroller integrated circuits
SocketCAN is a set of open source CAN drivers and a networking stack contributed by Volkswagen Research to the Linux kernel. SocketCAN was formerly known as Low Level CAN Framework (LLCF). Typical CAN communication layers. With SocketCAN (left) or conventional (right). Traditional CAN drivers for Linux are based on the model of character devices.
FatFs is a lightweight software library for microcontrollers and embedded systems that implements FAT/exFAT file system support. [1] Written on pure ANSI C, FatFs is platform-independent and easy to port on many hardware platforms such as 8051, PIC, AVR, ARM, Z80.
The Arduino Nano is equipped with 30 male I/O headers, in a DIP-30-like configuration, which can be programmed using the Arduino Software integrated development environment (IDE), which is common to all Arduino boards and running both online and offline. The board can be powered through a type-B mini-USB cable or from a 9 V battery. [2]