enow.com Web Search

  1. Ads

    related to: rubber caps for holes

Search results

  1. Results from the WOW.Com Content Network
  2. Stopper (plug) - Wikipedia

    en.wikipedia.org/wiki/Stopper_(plug)

    A bung can be defined as "a plug or closure used to close an opening in a drum or barrel. It is called a plug when referring to a steel drum closure." [1] A glass stopper is often called a "ground glass joint" (or "joint taper"), and a cork stopper is called simply a "cork". Stoppers used for wine bottles are referred to as "corks", even when ...

  3. Laboratory rubber stopper - Wikipedia

    en.wikipedia.org/wiki/Laboratory_rubber_stopper

    A laboratory rubber stopper or a rubber bung or a rubber cork is mainly used in chemical laboratories in combination with flasks and test tube and also for fermentation in winery. [1][2][3] Generally, in a laboratory, the sizes of rubber stoppers can be varied up to approximately 16 sizes and each of it is specific to certain type of container.

  4. Grommet - Wikipedia

    en.wikipedia.org/wiki/Grommet

    Grommet. A grommet is a ring or edge strip inserted into a hole through thin material, typically a sheet of textile fabric, sheet metal or composite of carbon fiber, wood or honeycomb. Grommets are generally flared or collared on each side to keep them in place, and are often made of metal, plastic, or rubber.

  5. Core plug - Wikipedia

    en.wikipedia.org/wiki/Core_plug

    Core plugs are usually thin metal cups press fitted into the casting holes, but may be made of rubber or other materials. The most common metal plugs used in automotive engines are made from plated mild steels, stainless steels, brass or bronze. In some high-performance engines the core plugs are large diameter cast metal threaded pipe plugs.

  6. Bunghole - Wikipedia

    en.wikipedia.org/wiki/Bunghole

    A bunghole is a hole bored in a liquid-tight barrel to remove contents. The hole is capped with a cork or cork-like stopper called a bung. Acceptable usage includes other access points that may be capped with alternate materials providing an air- or water-tight access to other vessels. For example, a bunghole on a combustion chamber can be used ...

  7. Piping and plumbing fitting - Wikipedia

    en.wikipedia.org/wiki/Piping_and_plumbing_fitting

    This view looking upwards through a hole in the ceiling shows a traditional leaded hub joint (at top) and a more recent rubber-sleeved hubless connection (at lower right). Because they operate at low pressure and rely on gravity to move fluids (and entrained solids), drain-waste-vent systems use fittings whose interior surfaces are as smooth as ...

  1. Ads

    related to: rubber caps for holes