Search results
Results from the WOW.Com Content Network
Reboot your modem/router - Sometimes the old "turn it off and on again" approach actually does work! Just wait about five minutes before turning it back on to make sure everything was reset. Just wait about five minutes before turning it back on to make sure everything was reset.
The person at computer B issues the modem escape command. (Alternately, and more commonly, the computer B could drop the DTR, or Data Terminal Ready signal, to achieve a hangup, without needing to use +++ or ATH.) OK: The modem acknowledges it. ATH: The person at computer B issues a hang up command. NO CARRIER: OK
The modem uses the Data Carrier Detect (DCD) pin to signal whether it's connected to a host. The computer can generally just read the DCD pin at any time and always know if the modem is in command or data mode. DCD high means data mode, and low means command mode. DCD is a signal sent from the modem to the computer.
Most computers have a reset line that brings the device into the startup state and is active for a short time after powering on. For example, in the x86 architecture, asserting the RESET line halts the CPU; this is done after the system is switched on and before the power supply has asserted "power good" to indicate that it is ready to supply ...
This is an accepted version of this page This is the latest accepted revision, reviewed on 2 December 2024. Restoring the software of an electronic device to its original state For the Tilian Pearson album, see Factory Reset (album). A factory reset, also known as hard reset or master reset, is a software restore of an electronic device to its original system state by erasing all data ...
The modem connects to a single computer or router, through an Ethernet port, USB port, or is installed in a computer PCI slot. The more common DSL router is a standalone device that combines the function of a DSL modem and a router , and can connect multiple computers through multiple Ethernet ports or an integral wireless access point .
The method for recording audio data is the same, except that the command is AT+VRX, or AT#VRX, and the modem transmits audio data while the computer receives it. The RTS/CTS flow control are not used here (the computer must accept all the audio data it receives, and the modem automatically paces its transmission to match the audio sampling rate).
Sometimes an interrupted flash upgrade of a PC motherboard will brick the board, for example, due to a power outage (or user impatience) during the upgrade process. It is sometimes possible to un-brick such a motherboard, by scavenging a similar but otherwise broken board for a BIOS chip in the hopes that the BIOS will work even halfway, far ...