Search results
Results from the WOW.Com Content Network
Cold shrink tubing is an open ended rubber sleeve, made primarily from rubber elastomers with high-performance physical properties, that has been factory expanded or pre-stretched, and assembled onto a supporting removable plastic core. [1]
The tube is also loosely held by two other dies, the wiper die and the pressure die. The process of tube bending involves using mechanical force to push stock material pipe or tubing against a die, forcing the pipe or tube to conform to the shape of the die.
Soft (or ductile) copper tubing can be bent easily to travel around obstacles in the path of the tubing. While the work hardening of the drawing process used to size the tubing makes the copper hard or rigid, it is carefully annealed to make it soft again; it is, therefore, more expensive to produce than non-annealed, rigid copper tubing.
Bend radius, which is measured to the inside curvature, is the minimum radius one can bend a pipe, tube, sheet, cable or hose without kinking it, damaging it, or shortening its life. The smaller the bend radius, the greater the material flexibility (as the radius of curvature decreases , the curvature increases ).
Bending is a cost-effective near net shape process when used for low to medium quantities. Parts usually are lightweight with good mechanical properties. A disadvantage is that some process variants are sensitive to variations in material properties. For instance, differences in spring-back have a direct influence on the resulting bend angle.
At the same time, William Elliott recognized the need and opportunity for efficient tube cleaning equipment and founded the Liberty Manufacturing Company in Jeannette, Pennsylvania. In 1916, William Elliott acquired Lagonda and fused the two companies into the Elliott Company, continuing to operate both plants in Ohio and Pennsylvania.
Tube sinking, also known as free tube drawing, reduces the diameter of the tube without a mandrel inside the tube. The inner diameter is determined by the inner and outer diameter of the stock tube, the outer diameter of the final product, the length of the die landing, the amount of back tension, and the friction between the tube and the die. [3]
A floating plug may also be inserted into the inside diameter of the tube to control the wall thickness. Wire drawing has long been used to produce flexible metal wire by drawing the material through a series of dies of decreasing size. These dies are manufactured from a number of materials, the most common being tungsten carbide and diamond.