Search results
Results from the WOW.Com Content Network
A crossflow head gives better performance than a Reverse-flow cylinder head (though not as good as a uniflow), but the popular explanation put forward for this — that the gases do not have to change direction and hence are moved into and out of the cylinder more efficiently — is a simplification since there is no continuous flow because of valve opening and closing.
2004–2011;The 2.5 Duratec is an inline 5 engine used in the Ford Focus ST225,Kuga,S-Max ST and various Volvo T5 models.It features DOHC, 20 valves and Ti-VCT.It displaces 2521cc and produces 166 kW (225hp) and 320 N.m (236lb.ft) in the ST or 227 kW (305hp) and 440 N.m (324.5lb.ft) in the Focus RS, or even up to 257kW (345hp) and 460 N.m ...
1919 Napier Lion II aircraft engine with three cylinder banks. Any design of motor/engine,be it a V or a boxer can be called an "in-line" if it's mounted in-line with the frame/chassis and in-line with the direction of travel of the vehicle.When the motor/engine is across the frame/chassis this is called a TRANSVERSE motor.Cylinder arrangement is not in the description of how the motor/engine ...
The key difference compared to crossflow scavenging is that the transfer ports are located either side of the exhaust port and aimed at the opposite cylinder wall. [3] As the fuel/air mixture enters the combustion chamber, it travels across the cylinder then up the cylinder wall opposite the exhaust port before looping over at the cylinder head ...
A crossflow T-head sidevalve engine The usual L-head arrangement Pop-up pistons may be used to increase compression ratio Flathead with Ricardo's turbulent head. A flathead engine, also known as a sidevalve engine [1] [2] or valve-in-block engine, is an internal combustion engine with its poppet valves contained within the engine block, instead of in the cylinder head, as in an overhead valve ...
The later "lean burn" versions of the engine launched in 1986 had reshaped combustion chambers to improve swirl, and were strictly speaking no longer hemi-headed at all. The CVH features hydraulic valve lifters, a first for a European Ford engine. In North America the engine was sold under different names, being called the "1.9L SEFI" from 1991 ...
The Ford flathead V8 (often called simply the Ford flathead or flathead Ford) is a V8 engine with a flat cylinder head introduced by the Ford Motor Company in 1932 and built by Ford through 1953. During the engine's first decade of production, when overhead-valve engines were used by only a small minority of makes, it was usually known simply ...
Cutaway view of the fuel system for the Ford Model T engine, showing the gravity-feed fuel supply, carburetor cutaway, and intake stream. [4] The Ford Model T engine had one carburetor, a side-draft, single-venturi unit. Its choke and throttle valves were controlled manually; the latter was with a hand lever rather than a foot pedal. The ...