Search results
Results from the WOW.Com Content Network
A tachometer (revolution-counter, tach, rev-counter, RPM gauge) is an instrument measuring the rotation speed of a shaft or disk, as in a motor or other machine. [1] The device usually displays the revolutions per minute (RPM) on a calibrated analogue dial, but digital displays are increasingly common.
The Astrarium had seven faces and 107 moving parts; it could show and predict the positions of the sun, the moon, stars and the five planets then known, as well as religious feast days. [ 9 ] Pascaline , 1642 – Blaise Pascal 's arithmetic machine primarily intended as an adding machine which could add and subtract two numbers directly, as ...
2007 Toyota Yaris hatchback owner's manual 1919 Ford Motor Company car and truck operating manual. An owner's manual (also called an instruction manual or a user guide) is an instructional book or booklet that is supplied with almost all technologically advanced consumer products such as vehicles, home appliances and computer peripherals.
A rev limiter is a device fitted in modern vehicles that have internal combustion engines. They are intended to protect an engine by restricting its maximum rotational speed, measured in revolutions per minute (RPM). Rev limiters are pre-set by the engine manufacturer. There are also aftermarket units where a separate controller is installed ...
The CD V-700 (often written as "CDV-700") is a Geiger counter employing a probe equipped with a Geiger–Müller tube, manufactured by several companies under contract to United States federal civil defense agencies in the 1950s and 1960s. While all models adhere to a similar size, shape, coloring and form-factor, there were substantial ...
Several mechanical counters Mechanical counter wheels showing both sides. The bump on the wheel shown at the top engages the ratchet on the wheel below every turn. Early IBM tabulating machine using mechanical counters. Mechanical counters are counters built using mechanical components. They typically consist of a series of disks mounted on an ...
Cutting speed may be defined as the rate at the workpiece surface, irrespective of the machining operation used. A cutting speed for mild steel of 100 ft/min is the same whether it is the speed of the cutter passing over the workpiece, such as in a turning operation, or the speed of the cutter moving past a workpiece, such as in a milling operation.
For forty years the arithmometer was the only type of mechanical calculator available for sale until the industrial production of the more successful Odhner Arithmometer in 1890. [8] The comptometer, introduced in 1887, was the first machine to use a keyboard that consisted of columns of nine keys (from 1 to 9) for each digit.