Search results
Results from the WOW.Com Content Network
The Wood method, also known as the Merchant–Rankine–Wood method, is a structural analysis method which was developed to determine estimates for the effective buckling length of a compressed member included in a building frames, both in sway and a non-sway buckling modes. [1] [2] It is named after R. H. Wood.
Rubberwood is a light-colored medium-density tropical hardwood obtained from the Pará rubber tree (Hevea brasiliensis), usually from trees grown in rubber plantations. [1] Rubberwood is commonly advertised as an "environmentally friendly" wood, as it makes use of plantation trees that have already served a useful function.
Rubber tapping in Indonesia, 1951. Rubber tapping is the process by which latex is collected from a rubber tree.The latex is harvested by slicing a groove into the bark of the tree at a depth of one-quarter inch (6.4 mm) with a hooked knife and peeling back the bark.
Illustration of uniform compression. The bulk modulus (or or ) of a substance is a measure of the resistance of a substance to bulk compression.It is defined as the ratio of the infinitesimal pressure increase to the resulting relative decrease of the volume.
As can be estimated from weight loss and the density , the wear coefficient can also be expressed as: [2] K = 3 H W P L ρ {\displaystyle K={\frac {3HW}{PL\rho }}} As the standard method uses the total volume loss and the total sliding distance, there is a need to define the net steady-state wear coefficient:
Specific modulus is a materials property consisting of the elastic modulus per mass density of a material. It is also known as the stiffness to weight ratio or specific stiffness.
Rubber, also called India rubber, latex, Amazonian rubber, caucho, or caoutchouc, [1] as initially produced, consists of polymers of the organic compound isoprene, with minor impurities of other organic compounds. Types of polyisoprene that are used as natural rubbers are classified as elastomers.
When testing wood in lumber form, the Janka test is always carried out on wood from the tree trunk (known as the heartwood), and the standard sample (according to ASTM D143) is at 12% moisture content and clear of knots. [3] The hardness of wood varies with the direction of the wood grain. Testing on the surface of a plank, perpendicular to the ...