Ads
related to: sterile water irrigation 1000 ml tubeebay.com has been visited by 1M+ users in the past month
Search results
Results from the WOW.Com Content Network
The volume of water used is normally about 1000 ml. [9] Some sources recommend repeat irrigation with a higher volume up to 2300 ml. [9] Transanal irrigation may be performed every day or every other day in order to simulate a normal defecation routine. [9] Ideally, irrigation is performed at the same hour each day. [10]
In this method a measured sub-sample (perhaps 10 ml) is diluted with 100 ml of sterile growth medium and an aliquot of 10 ml is then decanted into each of ten tubes. The remaining 10 ml is then diluted again and the process repeated. At the end of 5 dilutions this produces 50 tubes covering the dilution range of 1:10 through to 1:10000.
Orally, the solution may be taken in a wide variety of settings, and is usually taken at a rate of 240 mL (8 oz.) every 10 to 20 minutes. Nasogastrically, the solution is generally administered at a rate of 500 mL/h in children 9 months to 6 years, 1000 mL/h in children 6 to 12 years, and 1500 to 2000 mL/h in adolescents and adults. [ 4 ]
Saline solution for irrigation. Normal saline (NSS, NS or N/S) is the commonly used phrase for a solution of 0.90% w/v of NaCl, 308 mOsm/L or 9.0 g per liter. Less commonly, this solution is referred to as physiological saline or isotonic saline (because it is approximately isotonic to blood serum, which makes it a physiologically normal solution).
Gastric lavage, also commonly called stomach pumping or gastric irrigation, is the process of cleaning out the contents of the stomach using a tube. Since its first recorded use in the early 19th century, it has become one of the most routine means of eliminating poisons from the stomach. [ 1 ]
Water for injection is generally made by distillation or reverse osmosis. [5] It should contain less than a mg of elements other than water per 100 ml. [5] Versions with agents that stop bacterial growth are also available. [5] In the UK, some hospitals offer subcutaneous injections of water directly for treating back pain in labour.
The dilution of insulin is such that 1 mL of insulin fluid has 100 standard "units" of insulin. [6] A typical insulin vial may contain 10 mL, for 1000 units. Insulin syringes are made specifically for a patient to inject themselves, and have features to assist this purpose when compared to a syringe for use by a healthcare professional:
The water should be sterile or filtered for micro-organisms; if tap water is used it should be boiled and cooled. [4] Saline solution is also sometimes used. [2] The U.S. Centers for Disease Control and Prevention has a fact sheet recommending one of four methods to make the water safe: [8]
Ads
related to: sterile water irrigation 1000 ml tubeebay.com has been visited by 1M+ users in the past month