enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. RF modulator - Wikipedia

   en.wikipedia.org/wiki/RF_modulator

   The modulator is then programmed to broadcast the signals on a certain frequency. That RF broadcast is then received by the connected TV. When the TV is tuned to the programmed channel, the video and audio signal of the source device is accessed. RF modulation can become difficult in a CATV system. High pass, low pass, and notch filters must be ...

3. Digital television adapter - Wikipedia

   en.wikipedia.org/wiki/Digital_television_adapter

   A converter box takes the digital signal from the antenna and outputs composite video (for SD TVs) or HDMI (for HD TVs). A RF/antenna output, if present on a converter box, is usually just a passthrough ("LOOP OUT" which does not provide the box's output signal, but only provides the raw antenna input signal to watch analog channels via a TV ...

4. Sup'R'Mod - Wikipedia

   en.wikipedia.org/wiki/Sup'R'Mod

   Composite video is received by the circuit board through a short cable terminating in a Molex connector, which plugs into a header on the Apple II motherboard. Input can also be provided through an RCA connector. The output of the RF modulator goes out through a coaxial cable to the antenna switch. [5] [6]

5. Cable converter box - Wikipedia

   en.wikipedia.org/wiki/Cable_Converter_Box

   Pace Micro Technology DC757X HD cable box. A cable converter box or television converter box is an electronic tuning device that transposes/converts channels from a cable television service to an analog RF signal on a single channel, usually VHF channel 3 or 4, or to a different output for digital televisions such as HDMI.

6. Analog passthrough - Wikipedia

   en.wikipedia.org/wiki/Analog_passthrough

   Before digital television, passthrough originally existed in VCRs (and later PVRs and DVDRs) that connected to a TV set using RF connector, allowing the TV antenna or cable TV signal to be switched to pass through the VCR, or have VCR output added as an extra channel.

7. Composite video - Wikipedia

   en.wikipedia.org/wiki/Composite_video

   The process of modulating RF with the original video signal, and then demodulating the original signal again in the TV, introduces losses including added noise or interference. For these reasons, it is best to use composite connections instead of RF connections if possible for live signals and sample the source FM RF signal for recorded formats.