Search results
Results from the WOW.Com Content Network
Here the loop condition is defined using some value UNKNOWN, where the value of UNKNOWN is not known (e.g. defined by the user's input when the program is executed). Here the termination analysis must take into account all possible values of UNKNOWN and find out that in the possible case of UNKNOWN = 0 (as in the original example) the ...
The variant's value must decrease during each loop iteration but must never become negative during the correct execution of the loop. Loop variants are used to guarantee that loops will terminate. A loop invariant is an assertion which must be true before the first loop iteration and remain true after each iteration.
Thus the loop will always result in x = 2 and will never break. This could be fixed by moving the x = 1 instruction outside the loop so that its initial value is set only once. In some languages, programmer confusion about mathematical symbols may lead to an unintentional infinite loop. For example, here is a snippet in C:
The loop counter is used to decide when the loop should terminate and for the program flow to continue to the next instruction after the loop. A common identifier naming convention is for the loop counter to use the variable names i , j , and k (and so on if needed), where i would be the most outer loop, j the next inner loop, etc.
After a function's value is computed for that parameter or set of parameters, the result is stored in a lookup table that is indexed by the values of those parameters; the next time the function is called, the table is consulted to determine whether the result for that combination of parameter values is already available. If so, the stored ...
first checks whether x is less than 5, which it is, so then the {loop body} is entered, where the printf function is run and x is incremented by 1. After completing all the statements in the loop body, the condition, (x < 5), is checked again, and the loop is executed again, this process repeating until the variable x has the value 5.
The test for i < len is still present, but it has been moved outside the loop, which now contains only a single test (for the value), and is guaranteed to terminate due to the sentinel value. There is a single check on termination if the sentinel value has been hit, which replaces a test for each iteration.
If the variable has a signed integer type, a program may make the assumption that a variable always contains a positive value. An integer overflow can cause the value to wrap and become negative, which violates the program's assumption and may lead to unexpected behavior (for example, 8-bit integer addition of 127 + 1 results in −128, a two's ...