Search results
Results from the WOW.Com Content Network
A miter joint (mitre in British English) is a joint made by cutting each of two parts to be joined, across the main surface, usually at a 45° angle, to form a corner, usually to form a 90° angle, though it can comprise any angle greater than 0 degrees. It is called beveling when the angled cut is done on the side, although the resulting joint ...
Coping is only ever used for internal corners. External corners are always mitred. The main reason that scribed joints are used is that timber shrinks in width far more than it does in length. By using a scribed joint rather than an internal mitre joint, the effect of shrinkage is minimised. Also it is possible to arrange the scribed joints ...
In architecture, a baseboard (also called skirting board, skirting, wainscoting, mopboard, trim, floor molding, or base molding) is usually wooden, MDF or vinyl board covering the lowest part of an interior wall. Its purpose is to cover the joint between the wall surface and the floor.
A screw is then inserted through an opposing slot and tightened to create a pull effect. This type of join is a very common joint in factory-made furniture. Mitre joint: Similar to a butt joint, but both pieces have been beveled (usually at a 45-degree angle). Box joint: A corner joint with interlocking square fingers.
Mason's mitre in a kitchen countertop. A mason's mitre is a type of mitre joint, traditionally used in stonework or masonry but commonly seen in kitchen countertops.In a mason's mitre, the two elements being joined meet as for a butt joint but a small section of one member is removed creating a socket to receive the end of the other.
The earliest mitre clamps are a simple spring in a C-shape with sharpened points that are sprung onto the outside corner of the mitre joint. [citation needed]In a later design, right angled plates are higher than the screws and the holder.
A joint technique most commonly used in woodworking joinery. Noted for its resistance to being pulled apart (tensile strength), the dovetail joint is commonly used to join the sides of a drawer to the front. dowel A cylindrical piece of wood used as a pin for securing a joint. drawknife A cutting tool with two handles used for cutting large ...
A lap joint may be a full lap or half lap. In a full lap, no material is removed from either of the members that will be joined, resulting in a joint which is the combined thickness of the two members. In a half lap joint or halving joint, material is removed from both of the members so that the resulting joint is the thickness of the thickest ...