Search results
Results from the WOW.Com Content Network
A 3-port solenoid-type boost controller A 4-port solenoid-type boost controller (used for a dual-port wastegate). The purpose of a boost controller is to reduce the boost pressure seen by the wastegate's reference port, in order to trick the wastegate into allowing higher boost pressures than it was designed for.
However, the actual propeller speed remains stable only if operational conditions (e.g., airspeed) do not change, otherwise the pilot has to constantly adjust the pitch to maintain the desired propeller speed. Constant-speed propeller control system simplifies this for the pilot by introducing a propeller governor, where the lever controls the ...
If the aspect ratio is too large, the turbo will fail to create boost at low speeds; if the aspect ratio is too small, the turbo will choke the engine at high speeds, leading to high exhaust manifold pressures, high pumping losses, and ultimately lower power output. By altering the geometry of the turbine housing as the engine accelerates, the ...
This is exactly the opposite of the first port. The ability to help the wastegate remain closed as boost pressure builds can be increased. This also adds further complexity to boost control, requiring more control ports on the solenoid or possibly a complete second boost control system with its own separate solenoid.
A constant-speed propeller is a variable-pitch propeller that automatically changes its blade pitch in order to maintain a chosen rotational speed, regardless of the operational conditions of the aircraft. This is achieved by use of a constant-speed unit (CSU) or propeller governor, which automatically changes the propeller's blade pitch.
Download System Mechanic to help repair and speed up your slow PC. Try it free* for 30 days now.
This is commonly referred to as gauge pressure. Boost pressure is relative to absolute pressure - as one increases or decreases, so does the other. It is a one-to-one relationship with an offset of -100 kPa for boost pressure. Thus, a MAP sensor will always read 100 kPa more than a boost sensor measuring the same conditions.
Both use an eight-speed automatic transmission. Rear-wheel drive is standard on most models, with two different four-wheel-drive systems available: a part-time system with low range and a full ...