Search results
Results from the WOW.Com Content Network
Another method of reducing the fan speed [5] is by moving the 5 V wire in the classical Molex power connector in the place of the Ground wire going to the fan, thereby delivering +7 V (12 V − 5 V = 7 V) to the fan. However, this is a potentially risky method, because +5 V PSU line is intended to source current only, not sink it, so the PSU is ...
The speed of rotation (specified in revolutions per minute, RPM) together with the static pressure determine the airflow for a given fan. Where noise is an issue, larger, slower-turning fans are quieter than smaller, faster fans that can move the same airflow.
From a control standpoint, the main difference between PECI and the previously used thermal monitoring methods is that PECI reports a negative value expressing the difference between the current temperature and the thermal throttle point (at which the CPU reduces speed or shuts down to prevent damage due to overheating) instead of the absolute ...
For example, switching only has to be done several times a minute in an electric stove; 100 or 120 Hz (double of the utility frequency) in a lamp dimmer; between a few kilohertz (kHz) and tens of kHz for a motor drive; and well into the tens or hundreds of kHz in audio amplifiers and computer power supplies. Choosing a switching frequency that ...
SpeedFan is a system monitor for Microsoft Windows that can read temperatures, voltages and fan speeds of computer components. [3] It can change computer fan speeds depending on the temperature of various components. [1] [4] The program can display system variables as charts and as an indicator in the system tray.
MAP sensor data can be converted to air mass data by using a second variable coming from an IAT Sensor (intake air temperature sensor). This is called the speed-density method. Engine speed (RPM) is also used to determine where on a look up table to determine fuelling, hence speed-density (engine speed / air density).
Thermal Design Power (TDP), also known as thermal design point, is the maximum amount of heat that a computer component (like a CPU, GPU or system on a chip) can generate and that its cooling system is designed to dissipate during normal operation at a non-turbo clock rate (base frequency).
When the CPU is idle, it will draw far less than the typical thermal power. Datasheets normally contain the thermal design power (TDP), which is the maximum amount of heat generated by the CPU, which the cooling system in a computer is required to dissipate.