Search results
Results from the WOW.Com Content Network
Equal channel angular extrusion (ECAE) called also equal channel angular pressing (ECAP) is one technique from the Severe Plastic Deformation (SPD) group, aimed at producing Ultra Fine Grained (UFG) material. [1] The method was developed in the Soviet Union in 1973 by Segal. However, the dates are not always consistent. [2]
Three audio power amplifiers Rear panel of a power amplifier with 2 × 700 Watt (4 Ohm) - very similar to the topmost device in the image above - showing typical connectors for professional use: From left, symmetrical XLR-sockets for signal input, alternatively audio jack sockets, loudspeaker terminals of type Speakon (center), alternatively ...
The only terminal remaining is the source. This is a common-source FET circuit. The analogous bipolar junction transistor circuit may be viewed as a transconductance amplifier or as a voltage amplifier. (See classification of amplifiers). As a transconductance amplifier, the input voltage is seen as modulating the current going to the load.
In electronics, a common-gate amplifier is one of three basic single-stage field-effect transistor (FET) amplifier topologies, typically used as a current buffer or voltage amplifier. In this circuit, the source terminal of the transistor serves as the input, the drain is the output, and the gate is connected to some DC biasing voltage (i.e. an ...
Acoustic suspension or air suspension is a variation of the closed-box enclosure, using a box size that exploits the almost linear air spring resulting in a −3 dB low-frequency cut-off point of 30–40 Hz from a box of only one to two cubic feet or so. [16]
A mechanical amplifier or a mechanical amplifying element is a linkage mechanism that amplifies the magnitude of mechanical quantities such as force, displacement, velocity, acceleration and torque in linear and rotational systems. [1]
A bridge-parallel amplifier topology is a hierarchical combination of the bridged and paralleled amplifier topologies, with at least four single-ended channels needed to produce one bridge-parallel channel. The two topologies complement each other in that the bridging allows for higher voltage output and the paralleling provides the current ...
A microchannel plate is a slab made from resistive material (most often glass) 0.5 to 2mm thick with a regular array of tiny tubes (microchannels) leading from one face to the other. The microchannels are typically 5-20 micrometers in diameter, parallel to each other and enter the plate at a small angle to the surface (8-13° from normal ).