enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Power supply unit (computer) - Wikipedia

   en.wikipedia.org/wiki/Power_supply_unit_(computer)

   A power supply with a 24-pin connector can be used on a motherboard with a 20-pin connector. In cases where the motherboard has a 24-pin connector, some power supplies come with two connectors (one with 20-pin and other with 4-pin, i.e. 20+4-pin form) which can be used together to form the 24-pin connector.

3. ATX - Wikipedia

   en.wikipedia.org/wiki/ATX

   Originally, the motherboard was powered by one 20-pin connector. An ATX power supply provides a number of peripheral power connectors and (in modern systems) two connectors for the motherboard: an 8-pin (or 4+4-pin) auxiliary connector providing additional power to the CPU and a main 24-pin power supply connector, an extension of the original ...

4. PS-ON Signal - Wikipedia

   en.wikipedia.org/wiki/PS-ON_Signal

   #PS_ON pin is marked by number 16. PS-ON Signal is a pin on a 20-pin or 24-pin ATX-specified power connector used to turn a personal computer power supply unit on/off. The PS_ON pin is normally pulled high in an open-circuit, but will turn on the power supply when it is pulled low, by shorting it to the common signal (COM).

5. 16-pin 12VHPWR connector - Wikipedia

   en.wikipedia.org/wiki/16-Pin_12vHPWR_connector

   The connector was formally adopted as part of PCI Express 5. [1] The connector was replaced by a minor revision called 12V-2x6 (H++), introduced in 2023, [2] [3] which changed the GPU- and PSU-side connectors to ensure that the sense pins only make contact if the power pins are seated properly. The cables and their connectors remained unchanged ...

6. Molex connector - Wikipedia

   en.wikipedia.org/wiki/Molex_connector

   In 20/24-pin configurations, the Mini-Fit Jr. connector (Molex Mini-fit Jr. 39-28-1203, [7] former 5566-20A or 39-28-1243, [8] former 5566-24A) may be used on ATX motherboards as the main power connector. The same style of connector, in single or paired 4-, 6-, or 8-pin configurations, may be used for additional CPU power and graphics card ...

7. Berg connector - Wikipedia

   en.wikipedia.org/wiki/Berg_connector

   The power connector on the 3½-inch floppy drive, informally known as "the Berg connector", is 2.50 mm pitch (distance from center to center of pins). The power cable from the ATX power supply consists of 20 AWG wire to a 4-pin female connector. [ 1 ]

8. Power good signal - Wikipedia

   en.wikipedia.org/wiki/Power_good_signal

   The ATX specification defines the Power-Good signal as a +5-volt (V) signal generated in the power supply when it has passed its internal self-tests and the outputs have stabilized. This normally takes between 0.1 and 0.5 seconds after the power supply is switched on.

9. AT (form factor) - Wikipedia

   en.wikipedia.org/wiki/AT_(form_factor)

   Baby AT motherboard An ATX Form Card, used by later Baby-AT motherboards to allow for USB, PS/2 mouse, and IR connectivity through headers. In 1987, the Baby AT form factor was introduced, based on the motherboard found in the IBM PC/XT 286 (5162) [2] and soon after all computer makers abandoned AT for the cheaper and smaller Baby AT form factor, using it for computers that spanned several ...