Search results
Results from the WOW.Com Content Network
A cun (Chinese: 寸 ts'wun; Pinyin cùn IPA |mi=), often glossed as the Chinese inch, is a traditional Chinese unit of length.Its traditional measure is the width of a person's thumb at the knuckle, whereas the width of the two forefingers denotes 1.5 cun and the width of four fingers (except the thumb) side-by-side is 3 cuns. [1]
Converts measurements to other units. Template parameters [Edit template data] This template prefers inline formatting of parameters. Parameter Description Type Status Value 1 The value to convert. Number required From unit 2 The unit for the provided value. Suggested values km2 m2 cm2 mm2 ha sqmi acre sqyd sqft sqin km m cm mm mi yd ft in kg g mg lb oz m/s km/h mph K C F m3 cm3 mm3 L mL cuft ...
The centimetre (SI symbol: cm) is a unit of length in the metric system equal to 10 −2 metres ( 1 / 100 m = 0.01 m). To help compare different orders of magnitude, this section lists lengths between 10 −2 m and 10 −1 m (1 cm and 1 dm). 1 cm – 10 millimeters; 1 cm – 0.39 inches; 1 cm – edge of a square of area 1 cm 2
Subdivisions of an inch are typically written using dyadic fractions with odd number numerators; for example, two and three-eighths of an inch would be written as 2 + 3 / 8 ″ and not as 2.375″ nor as 2 + 6 / 16 ″. However, for engineering purposes fractions are commonly given to three or four places of decimals and have been ...
Therefore, they are generally taxed as 1.5 times [citation needed] their stated physical displacement (1.3 litres becomes effectively 2.0, 2.0 becomes effectively 3.0), although actual power outputs can be higher than suggested by this conversion factor. The nominal displacement of a Wankel engine is 3 times smaller than the physical ...
The miner’s inch measures the amount of water that would flow through a slot of a given area at a given pressure (for example, at a head of 6 inches of water, or 1.5 kPa.) In miner's inch the word inch refers to the area of the slot in square inches, while the pressure in inches of water refers to the height of water above the slot. A ...
The palm was divided into four digits (digitus) of about 1.85 cm (0.7 in) or three inches (uncia) of about 2.47 cm (1.0 in). Three made a span ( palmus maior or "greater palm") of about 22.2 cm (9 in); [ d ] four, a Roman foot ; five, a hand-and-a- foot ( palmipes ) of about 37 cm (1 ft 3 in); six, a cubit ( cubitus ) of about 44.4 cm (1 ft 5.5 ...
A less precise definition is one pica equals 0.166 inches (4.2 mm), and one point 0.01383 inches (0.351 mm). [27] [33] It was also noticed that 83 picas is nearly equal to 35 cm, so the Type Founders Association also suggested using a 35 cm metal rod for measurements, but this was not accepted by every foundry. [27]