Search results
Results from the WOW.Com Content Network
The keyboard controller also handles PS/2 mouse input if a PS/2 mouse port is present. Today the keyboard controller is either a unit inside a Super I/O device or is missing, having its keyboard and mouse functions handled by a USB controller and its role in controlling the A20 line becoming integrated into the chipset's northbridge and then ...
At the destination, a second UART re-assembles the bits into complete bytes. Each UART contains a shift register, which is the fundamental method of conversion between serial and parallel forms. Serial transmission of digital information (bits) through a single wire or other medium is less costly than parallel transmission through multiple wires.
Asynchronous start-stop is the lower data-link layer used to connect computers to modems for many dial-up Internet access applications, using a second (encapsulating) data link framing protocol such as PPP to create packets made up out of asynchronous serial characters. The most common physical layer interface used is RS-232D.
The AVRISP connects to a PC via a serial port and draws power from the target system. The AVRISP allows using either of the "standard" ICSP pinouts, either the 10-pin or 6-pin connector. The AVRISP mkII connects to a PC via USB and draws power from USB. LEDs visible through the translucent case indicate the state of target power.
Input and output voltages are usually, but not always, limited to the supply voltage of the device with the GPIOs, and may be damaged by greater voltages. A GPIO pin's state may be exposed to the software developer through one of a number of different interfaces, such as a memory-mapped I/O peripheral, or through dedicated IO port instructions.
For example, on the original IBM PC, a male D-sub was an RS-232-C DTE port (with a non-standard current loop interface on reserved pins), but the female D-sub connector on the same PC model was used for the parallel "Centronics" printer port. Some personal computers put non-standard voltages or signals on some pins of their serial ports.
It is sometimes called a four-wire serial bus to contrast with three-wire variants which are half duplex, and with the two-wire I²C and 1-Wire serial buses. Typical applications include interfacing microcontrollers with peripheral chips for Secure Digital cards, liquid crystal displays , analog-to-digital and digital-to-analog converters ...
A male D-subminiature connector used for an RS-232 serial port on an IBM PC compatible computer along with the serial port symbol. A serial port is a serial communication interface through which information transfers in or out sequentially one bit at a time. [1]