Search results
Results from the WOW.Com Content Network
Wireless Zero Configuration (WZC), also known as Wireless Auto Configuration, or WLAN AutoConfig, is a wireless connection management utility included with Microsoft Windows XP and later operating systems as a service that dynamically selects a wireless network to connect to based on a user's preferences and various default settings.
Linux also features iwspy, to read the signal, noise and quality of a wireless connection. Other related tools for configuring Ethernet adapters are: ethtool, mii-tool, and mii-diag in Linux and the command dladm show-link in Solaris. The ip suite has a similar purpose and is meant to replace the deprecated ifconfig. [6]
Monitor mode only applies to wireless networks, while promiscuous mode can be used on both wired and wireless networks. Monitor mode is one of the eight modes that 802.11 wireless adapter can operate in: Master (acting as an access point), Managed (client, also known as station), Ad hoc, Repeater, Mesh, Wi-Fi Direct, TDLS and Monitor mode.
Wi-Fi Direct is a Wi-Fi standard for wireless connections [1] that allows two devices to establish a direct Wi-Fi connection without an intermediary wireless access point, router, or Internet connection. Wi-Fi Direct is single-hop communication, rather than multi-hop communication like wireless ad hoc networks. The Wi-Fi Direct standard was ...
Because of the nature of the NAT, IP addresses on the local computer are not visible on the Internet. All packets leaving or entering the LAN are sent from or to the IP address of the external adapter on the ICS host computer. Typically, ICS can be used when there are several network interface cards installed on the host computer. In this case ...
This feature is not exposed through the GUI; however the Virtual WiFi Miniport adapter can be installed and enabled for wireless adapters with drivers that support a hosted network by using the command netsh wlan set hostednetwork mode=allow "ssid=<network SSID>" "key=<wlan security key>" keyusage=persistent|temporary at an elevated command ...
The command removes and corrects preloaded entries using a number of case-sensitive switches. The nbtstat -a < name > command performs a NetBIOS adapter status command on the computer name specified by < name >. The adapter status command returns the local NetBIOS name table for that computer as well as the MAC address of the
A wireless network interface controller may be implemented as an expansion card and connected using PCI bus or PCIe bus, or connected via USB, PC Card, ExpressCard, Mini PCIe or M.2. The low cost and ubiquity of the Wi-Fi standard means that many newer mobile computers have a wireless network interface built into the motherboard.